Otolift Type 87 87
Manuals and User Guides for Otolift Type 87 87. We found 1 manuals for free downloads Manual
The Otolift Type 87 is a stairlift system designed for use on staircases. It features a closed-loop control system for controlling the synchronous motor and DC brake. The lift is equipped with an on-board charging circuit for charging the batteries. This model includes a buzzer on the PCB and a LED in the armrest to report failures to the user, and a display on the PCB for reporting failures to the mechanic or installer.
Key Features
Closed-loop control system
On-board charging circuit
Armrest LED for user failure report
PCB display for mechanic failure report
Error log for backwards failure handling
Frequently Answers and Questions
How do I program the chairlift?
The chairlift must be programmed when moving to the right, seen from the user position. Ensure that the lift stops at the endswitches, set the speed using the potentiometer, and follow the programming steps in the manual.
What to do if there is a mechanical error?
The display on the PCB shows the actual error code. Refer to the manual for the explanation of the errors and LED indicators.
What does it mean when the chairlift beeps?
The chairlift might beep for multiple reasons. There is a specialized mechanic-needed-beep. This is indicated by the display showing an 8888x error. Refer to the manual for further explanation.
How to charge the batteries?
The charging voltage is interconnected through the charging contacts, as detailed in the drawing 86900 LD eng. The maximum charge current is 1.1A. Don't use a standard battery charger, use only the transformer delivered by Otto Ooms BV.
What are the different types of powered hinges available?
Two different powered hinges are available: a powered sliding hinge and a powered folding hinge. The powered sliding hinge requires less space than the powered folding hinge when folded in. The powered sliding hinge uses extra remote controls for moving the hinge up/down, while the folding hinge is controlled by an extra PCB in the chairlift itself.
How do I reset the chairlift after an 8888x error?
After solving the problem that caused the 8888x error, reset the chairlift by operating the lift left or right for 10 seconds. When the fast beep has stopped during operating left/right, the error is resetted and solved.
Questions & Answers
A A A
How to install chairlift endpoints?
- Identify the chairlift's top and bottom stop locations. 2. Attach the safety-cap endswitches at these points. 3. Connect the endswitches to the PCB using the wiring diagram. 4. Verify the chairlift stops when the endswitches are activated.
Is it possible to program the Otolift Type 87 without the device box?
Programming the Otolift Type 87 typically requires the service box, as described in the manual. Alternative programming methods without it are not specified.
What happens when the safety drive unit on the right side is controlled?
When the safety drive unit on the right side is controlled, the chairlift's movement is restricted to the left direction only.
advertisement