Russell Hobbs Turbo Lite RHCHS10SB02

To assemble the vacuum cleaner, first place the extension tube onto the cleaner's nozzle, ensuring that the protruding tabs are lined up with the grooves in the telescopic tube. Rotate the tube from the "OPEN" to the "LOCK" position. Then, slot the cleaning head on to the end of the extension tube. Finally, adjust the telescopic tube to the desired height by pushing the tube extension button upwards and pulling the inner tube downwards.

To empty the dust container, first press the release button on the top of the vacuum cleaner and lift the dust container clear of the base. Then, press down the button on the side of the dust container below the nozzle to open the bottom and release the dust. Once empty, close the bottom of the dust container and clip it back into the vacuum cleaner unit, ensuring the bottom of the dust container is correctly located before the release button clicks back into place.

To clean the filter, first remove the dust container. Then, unclip the filter release clips on both sides of the dust container and remove the filter assembly. Twist the lid of the dust container assembly to the UNLOCK position and remove it. Then, remove the sponge and HEPA filters. To clean, remove excess dust from the filter using a soft brush. Wash in warm water and allow to dry for 24 hours. Replace the filters, then twist the lid of the dust container to the LOCK position. Refit the dust container.