6175 Manuals

Ryobi P230

Manuals and User Guides for Ryobi P230. We found 4 manuals for free downloads Operator's manual, Owner's manual

Below you will find brief information for impact driver P230. The impact driver P230 is an 18 volt cordless impact driver that is engineered for dependability and ease of operation. It features a 1/4 inch coupler that accepts standard 1/4 inch hex bits, a built-in bit storage, and a variable speed switch that delivers higher speed and torque with increased trigger pressure. It is also reversible, allowing you to tighten or loosen screws.

Key Features

18 volt cordless impact driver
1/4 inch coupler
built-in bit storage
variable speed switch
reversible
3,500 blows per minute

RYOBI impact driver P230 Operator's Manual

Pages: 16 Ryobi P230 Operator's manual

Brand: Ryobi Category: Power impact wrenches Size: 958 KB

Languages: English

Open manual

Frequently Answers and Questions

What is the purpose of the direction of rotation selector?

The direction of rotation selector controls the direction of the tool. When the selector is to the left of the switch, the tool is set to tighten. When the selector is to the right of the switch, the tool is set to loosen. The selector can also be placed in the center position to lock the switch trigger.

How do I charge the battery pack?

To charge the battery pack, connect the charger to a power outlet and then place the battery pack in the charger, aligning the raised rib on the battery pack with the groove in the charger. The red LED on the charger will come on, indicating that the charger is in fast charging mode. The red LED should remain on for approximately 1 hour, then the green LED will come on, indicating that the battery pack is fully charged and the charger is in maintenance charge mode. The green LED will remain on until the battery pack is removed from the charger or the charger is disconnected from the power supply.

How do I install and remove bits?

To install a bit, slide the coupler forward and hold it in position. Insert the bit straight into the coupler. Slide the coupler back slowly and release. To remove a bit, slide the coupler forward and hold it in position. Pull the bit straight out of the coupler.