1. manualzz.com
  2. home
  3. Do-It-Yourself tools
  4. power tools
  5. power chainsaws

Ryobi RY10520

Manuals and User Guides for Ryobi RY10520. We found 2 manuals for free downloads Operator's manual

Below you will find brief information for Chain Saw RY10520 and RY10518. This manual provides instructions on the safe operation, maintenance, and assembly of Ryobi chain saws. It covers fuel handling, starting procedures, cutting techniques, and safety precautions, including kickback avoidance and proper handling of fuel. This manual is crucial for ensuring the longevity and safe use of your equipment.

Key Features

  • 46cc Engine

  • 20 in. or 18 in. Bar Length

  • Chain Brake

  • Primer Bulb

  • SAFE-T-TIP Nose Guard

  • Low Kickback Chain

Pages: 41 Ryobi RY10520 Operator's manual

Brand: Ryobi Category: Power chainsaws Size: 5 MB

Languages: English

Table of contents

Open manual

Other manuals and documents

118 Pages

Operator's manual

Languages: English, Spanish, French

Frequently Answers and Questions

How do I start a cold engine?

Set the ignition switch to the RUN position. Make sure the chain brake is in the run position. Fully press and release the primer bulb 7 times. Pull the choke lever all the way out to FULL CHOKE. Pull the starter grip until the engine attempts to start, but no more than 3 or 5 times depending on temperature. Push the choke lever to RUN. Pull starter grip until engine runs.

How do I stop the engine?

Release the throttle trigger and let the engine return to idle. Move the ignition switch to the STOP position.

What type of fuel should I use?

Use unleaded gasoline intended for motor vehicle use with an octane rating of 87 [(R + M) / 2] or higher. This product is powered by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle lubricant. Mix 2% lubricant into the gasoline (50:1 ratio).

What precautions should I take to avoid kickback?

Keep a good firm grip on the saw with both hands. Make sure the area is free from obstructions. Cut at high engine speeds. Do not overreach or cut above chest height. Follow the manufacturer’s sharpening and maintenance instructions.

How often should I check and operate chain brake?

Check the operating condition of the chain brake prior to each use. Engage the chain brake and reset to RUN position by grasping the top of the chain brake lever/hand guard and pulling toward the front handle until you hear a click.

advertisement