4002 Manuals

SICK CLP 100

Manuals and User Guides for SICK CLP 100. We found 2 manuals for free downloads Operating instructions

Below you will find brief information for Bar Code Reader CLP 100. The CLP 100 is a barcode reader that is used to automatically detect and decode barcodes. It is installed as a reading station and reads barcodes on objects, such as those in a clinical automatic analyzer. The CLP 100 transmits the decoded bar code information via its host interface to a host computer for further processing.

Key Features

CCD bar code reader
RS-232 interface
Default setting for many applications
Decoding various bar code types
Reading distance up to 70 mm
Parameterization via CLP Setup software
External sensor triggering
Diagnosis mode for quality check
Switching output for control purposes

Bar Code Reader CLP 100 Operating Instructions

Pages: 44 SICK CLP 100 Operating instructions

Brand: SICK Category: Electrical equipment & supplies Size: 699 KB

Languages: English

Open manual

Frequently Answers and Questions

What are the system requirements for operating the CLP 100?

The CLP 100 requires a 5V DC power supply, a PC with Windows 95, 98 or NT and a serial interface, an RS-232 data connection cable, a sensor for object detection (if external reading pulsing is used), and an HTML browser for the CLP Setup Help on-line help system.

How do I connect the external reading pulse sensor to the CLP 100?

Connect the sensor to the "Sensor" switching input on the CLP 100. The wiring diagram is provided in the document.

What is the default setting of the CLP 100?

The default setting includes Code 39 as the active code type, free code length, multiple reading of 2, reading direction of both, no check digit, active low reading pulse generation, inactive switching output, RS-232 host interface with STX start characters and ETX stop characters, 9600 bits/s transmission rate, 8 data bits, no parity, 1 stop bit, and "BR" as the No Read message.

How do I adjust the CLP 100 to the bar code?

Use the adjusting mode in the CLP Setup software to align the CLP 100 for optimal reading results. The green LED will light up steadily when the CLP 100 is aligned correctly.

How do I change the communication parameters of the host interface?

You can change the communication parameters using the CLP Setup software. The default settings are 9600 bits/s transmission rate, 8 data bits, no parity, and 1 stop bit.

How do I dispose of the CLP 100?

Dispose of the unusable or irreparable device ecologically friendly by separating it into recyclable secondary raw materials (housing) and hazardous waste (electronic scrap) according to local regulations.