Sanav GC-101

The RT-99 is a vibration-actuated DC power switch that allows you to connect a 3.7V 6600mAh battery to a SANAV GC-101 or CT-24 GPS tracker.

The RT-99 detects motion using a vibration sensor. When it detects motion, it turns on the power to the GPS tracker. Once the motion has ceased, the RT-99 will keep the power on for a programmable period of time before turning it off.

The power-on delay time is the amount of time that the RT-99 will keep the power on to the GPS tracker after the motion has ceased. You can program the power-on delay time to be 5, 10, 15, or 20 minutes.

To program the power-on delay time, press the "Power-ON Delay Time" toggle button quickly. Next to the button are two small yellow LEDs, which will either be ALWAYS-ON BRIGHT, ALWAYS-ON DIM or UNLIT to indicate the ‘Power-ON Delay Time’ which is currently programmed in the RT-99. Press the toggle button once for 3 seconds and the LED’s which are always-on will FLASH to indicate that the RT-99 is now in programming mode. Press the button quickly 3-4 times to toggle through the four ‘Power-ON Delay Time’ options on the RT-99. Press the toggle button a couple of times until the desired ‘Power-ON Delay Time’ is selected. When the desired Power-ON delay time is confirmed by the flashing yellow LED’s, press the toggle button once for about 3 seconds again to confirm the setting. This turns off all the yellow LED’s and puts the RT-99 into normal operation.

To charge the battery, move the ‘Power Hibernation/Battery Charge’ switch on the RT-99 to the right hand side and connect the mains AC charger to the 15-pin connector on the GC-101. The mains charger will fully charge the 6600mAh battery via the RT-99 in about 5-6 hours.