777 Manuals

TOHATSU BFT 150A

Manuals and User Guides for TOHATSU BFT 150A. We found 8 manuals for free downloads Owner's manual

Below you will find brief information for outboard motor BFT 115A, outboard motor BFT 150A. The outboard motor is designed for the safe and dependable service when operated according to the instructions described in this manual. This manual will cover operation and maintenance procedures that may be required to ensure the continued safe and reliable operation of your outboard motor. The TOHATSU outboard motor is designed to give safe and dependable service if operated according to instructions. Read and understand the Owner’s Manual before operating the outboard motor. Failure to do so could result in personal injury or equipment damage.

Key Features

Remote Control Lever
Engine Switch
Power Trim/Tilt Switch
Emergency Stop Switch
Manual Relief Valve
Engine Oil
Fuel
Propeller
Battery
Engine Protection System

Pages: 130 TOHATSU BFT 150A Owner's manual

Brand: TOHATSU Category: Engine Size: 8 MB

Languages: en

Open manual

Frequently Answers and Questions

What is the proper procedure for starting the engine?

The engine is equipped with programmed fuel injection for starting. To start the engine, engage the emergency stop switch clip, set the remote control lever to the NEUTRAL position, turn the engine switch to the START position. After the engine starts and if the outside temperature is below 5°C (41°F), the fast idle lever/fast idle button can be used to accelerate engine warm up.

How do I shift the gears?

When shifting the gears, move the remote control lever to the forward position (i.e. approximately 30° from the NEUTRAL position) to engage the gear into forward. Further movement of the lever will increase the throttle opening and boat forward speed. For reverse, move the lever to the REVERSE position (i.e. approximately 30° from the NEUTRAL position) to engage the gear into reverse. Further movement of the lever will increase the throttle opening and boat reverse speed. For NEUTRAL, the engine power is cut off from the propeller.

What is the correct transom height for this outboard motor?

For the BFT115A/150A, there are two transom heights: 508 mm (20.0 in) and 635 mm (25.0 in). To determine the correct transom height, the anticavitation plate should be 0 – 25 mm (0 – 1 in) below the bottom of the boat. The water level must be at least 100 mm (4 in) above the anticavitation plate, otherwise, the water pump may not receive sufficient cooling water, and the engine will overheat.