Ultra Reef UCS-100

Manuals and User Guides for Ultra Reef UCS-100. We found 1 manuals for free downloads instruction manual

Ultra Reef UCS-100 is a CO2 reactor designed for aquariums. It helps to lower the pH level in your aquarium water by injecting CO2 into the water. The device uses a specific type media for this process. It has a built-in bubble counter for monitoring the CO2 flow.

Key Features

  • CO2 reactor
  • pH control
  • media-based
  • bubble counter
  • aquarium use
  • in-tank sump installation
  • manual and PH controller regulation

Pages: 4 Ultra Reef UCS-100 instruction manual

Brand: Ultra Reef Category: Above ground pools Size: 377 KB

Languages: English

Open manual

Frequently Answers and Questions

How do I start the reactor?
1. Loose the breather/probe port on the cover. 2. Connect the water inlet (or start the pump load) of the reactor. 3. Loose the upper connector on the bubble counter and fill it with water. 4. Shake the reactor gently to release air bubbles. 5. Tighten the breather/probe port and check for water discharge. 6. Start the reactor's pump. 7. Close the output valve to achieve a flow of 1-2 l/h. 8. Open the CO2 cylinder valve and adjust pressure to 0.1 bar. 9. Verify CO2 release through the bubble counter. (Viewed document)
What type of media is used in the reactor?
The media is the filling material of the reactor. You need to prepare it before installing the reactor following the instructions provided by the media supplier. (Viewed document)
How often do I need to maintain the reactor?
Daily: Check for leaks and cracks. Verify CO2 input and water outflow. Ensure no air bubbles are present. Weekly: Measure output flow and KH° value, adjust CO2 input if needed. Check tank values and buffer with liquid or powder if necessary. Monthly: Remove drain valve and clean or replace it. Every six months: Perform a complete check and replace the media. (Viewed document)

advertisement