Universal Tool UT8748-4

Manuals and User Guides for Universal Tool UT8748-4. We found 1 manuals for free downloads User manual

Below you will find brief information for Angle Grinder UT8748-4. This manual provides safety information, installation and operation instructions for the Angle Grinder UT8748-4. It details how to install and remove the grinding wheel. Additional information includes troubleshooting and maintenance instructions.

Key Features

  • Low Profile
  • 4-in. Wheel
  • Rear Exhaust
  • Safety Lock-Off
  • 90 PSIG Operation
  • 13,500 RPM Speed
  • ANSI Approved Grinding Stones
  • Pin Wrench and Spanner Wrench
  • In-Line Lubricator

Pages: 8 Universal Tool UT8748-4 User manual

Brand: Universal Tool Category: Power tools Size: 1 MB

Languages: English

Open manual

Frequently Answers and Questions

What is the recommended air pressure for operating the angle grinder?
The recommended air pressure is 90 PSIG. Lower pressure will reduce performance, and higher pressure could damage the tool and user.
What type of grinding wheels should be used with this angle grinder?
Always use ANSI approved grinding stones with the rated tool RPM.
How do I lubricate the angle grinder?
An in-line filter-regulator-lubricator is recommended. Regularly check and fill the in-line lubricator with air tool oil. Adjust the lubricator by placing a sheet of paper next to the tool's exhaust ports and holding the throttle open for 30 seconds. The lubricator is properly set when a light stain of oil collects on the paper.
What are the safety precautions when operating the angle grinder?
Always wear ANSI approved eye protection and hearing protection. A protective respirator is also recommended. Disconnect the tool from the air supply before servicing or changing accessories. Ensure the air line is shut-off and drained of air before removing the tool for service or changing sockets.

advertisement