413 Manuals

Vita MT MAXIMA

Manuals and User Guides for Vita MT MAXIMA. We found 1 manuals for free downloads Installation and operating instructions

Below you will find brief information for spa MT MAXIMA, spa MT MT15, spa MT MT10. The MT series spas are equipped with advanced safety features and self-protective devices. This document will guide you through the installation and operation of your spa. This will include step-by-step instructions on how to fill the spa, start it up, and use its various features. Additionally, it provides information on maintaining clean and sanitary water, draining the spa, and protecting it from freezing.

Key Features

Four function air switch
Timer operation
Thermostat setting
Jet operation
Air control operation
Air finger massage jets
Wooden skirt
Spa cover
Acrylic surface
Filter

Vita Spa MT MAXIMA, MT MT15, MT MT10 Installation & Operating Instructions

Pages: 12 Vita MT MAXIMA Installation and operating instructions

Brand: Vita Category: Bath appliances Size: 909 KB

Languages: English

Open manual

Frequently Answers and Questions

How often do I need to clean my spa filter?

The amount of use, the user load, and the water temperature will determine the frequency of recommended cleanings. Using a garden hose will remove the larger debris on the filter, but it will not dissolve the body oils. Filter cleaners are available from your dealer.

What do I do if my spa's high limit trips?

The high limit reset button (silver) is located on the top center of the heater housing by the red heater indicator light. If the water becomes too hot, this button will trip and discontinue power to the heater element. When the water temperature has cooled below 80 degrees, you can manually reset the high limit by depressing the button.

How do I set the timer on my spa?

After you have set the timer to the actual time of day, set the amount of “RUN” time you would like to have the spa operate (FILTRATION/HEAT) and at which times of the day/night by sliding the proper pins in towards the center of the face. Each pin represents 15 minutes. If you wanted to have the spa “RUN” from 1 PM to 5 PM, you would need to slide the pin in at 1 PM, at 5 PM, and all the pins in between in order for the low-speed pump to operate during that time.