1. manualzz.com
  2. home
  3. Do-It-Yourself tools
  4. power tools
  5. Floor Machine

WerkMaster THE EDGE

Manuals and User Guides for WerkMaster THE EDGE. We found 1 manuals for free downloads Operator's manual

Below you will find brief information for Floor Sander RASP, Floor Grinder THE EDGE. The RASP sander is designed to meet the needs of contractors, facility services, equipment rentals, and DIYers. The RASP can easily remove glue, wax, varnish, shellac, and aluminum oxide factory finishes. Use the RASP on engineered hardwood, solid hardwood, wood decks, plywood subfloors to sand and edge. The EDGE grinder is designed to meet the needs of contractors, facility services, equipment rentals, and DIYers. The EDGE can be used to grind and polish concrete. Use the EDGE to grind and polish concrete.

Key Features

  • Lightweight & easy to maneuver

  • Variable frequency drive lets you run at speeds from 400 RPM to 1000 RPM

  • Features 3HP 220V high efficiency motor (available with 1.5 HP motor)

  • Edge to within 1/8” (3 mm) of the wall

  • Disassembles for easy lifting and transport

Pages: 25 WerkMaster THE EDGE Operator's manual

Brand: WerkMaster Category: Floor Machine Size: 1 MB

Languages: English

Table of contents

Open manual

Frequently Answers and Questions

What type of power cord is required for the RASP or THE EDGE?

The minimum requirements for power cords are listed in the Power Cord Minimum Requirements table on page 4 of the document.

How do I change the primary belt on the RASP or THE EDGE?

Follow the steps outlined in the Changing the Primary Belt section of the manual. Disconnect the power and ensure the handle is in the upright position.

How do I adjust the handle on the RASP or THE EDGE?

To adjust the handle, pull the pin (H) on the handle, adjust the handle to a comfortable operating position, and then release the pin. Failure to check the pull pin is fully engaged could result in damage to the machine or personal injury as the handle could release unexpectedly when the machine is being operated or tilted back.

Can I operate the RASP or THE EDGE on 110V?

The RASP and THE EDGE can be operated on 110V with a Quick 220 Adapter. You can connect two 110V cords from the Quick 220 into the 110V wall outlet on two (2) separate circuits on opposite sides of the panel. Plug the WerkMaster machine into the Quick 220 adapter.

advertisement