ADC Adscope

To select a side, hold the chestpiece valve stem in one hand and rotate the chestpiece 180° with the other hand until it “clicks” into place. The stem has a slight bend, the high point of the bend faces the activated side.

The binaurals (eartubes) are angled at 15° to permit a comfortable, acoustically sealed aural fit. Eartips should point forward, towards the bridge of the nose to fit properly.

All ADSCOPES™ (except #600 Platinum Cardiology, #601 Convertible Cardiology and #602 Cardiology models) are equipped with 22” tubing for convenience. If a shorter length is desired, remove chestpiece from tubing. Cut tubing to desired length with a sharp single edge razor on a hard surface. Soften tubing by immersing in hot water for approximately one minute, and reinsert chestpiece stem in tubing. CAUTION: Allow tubing to cool after immersing in hot water before handling.

Your ADSCOPE™ is equipped with up to two ultrasensitive, yet extremely durable, diaphragms formed from a compound of epoxy resin fiberglass. It is unlikely that they will ever need replacement. To replace the Snap-on (PVC) Rim: Snap off the rim and remove the worn diaphragm. Replace with new diaphragm and reattach rim by gently stretching rim until the chestpiece edge inserts fully in the track within the rim. To replace Threaded (Metal) Rim: Turn rim counterclockwise to remove. Replace with new diaphragm and reattach rim by turning clockwise until tight to re-assemble.

Avoid extreme heat, cold, solvents, or oils. Do NOT leave exposed to direct sunlight for prolonged periods of time. Binaurals and tubing can be wiped down with alcohol or mild soapy water. Eartips may be unscrewed from binaurals for a thorough cleaning. Periodically check that eartips are tightly secured to binaurals. Do NOT immerse stethoscope in any liquid or subject to steam sterilization. If sterilization is necessary, gas sterilize only. Chestpieces and diaphragms can be wiped down with alcohol for cleaning purposes.