1. manualzz.com
  2. entertainment & hobby
  3. musical instruments
  4. Musical Equipment

teleCARE LED Lamp Boards

Manuals and User Guides for teleCARE LED Lamp Boards. We found 1 manuals for free downloads User manual

Below you will find brief information for IP Room Controller NIRC GMS, IP Room Controller NIRC WMS, IP Room Controller NIRC3. This guide will help you install your IP Room Controller and connect it to your teleCARE system. The IP Room Controller is designed to work with teleCARE IP, allowing you to control room functions such as lighting, temperature, and door access. This IP Room Controller can be easily installed and configured and is compatible with other teleCARE products.

Key Features

  • NIRC GMS and NIRC WMS features

  • NIRC3 model capabilities

  • LED Lamp Boards connections

  • Transceiver Piggyback Module NIRX

  • Voice Piggyback NIVP installation

  • Room Controller installation steps

  • Room bus connections

  • Power supply wiring

  • External Corridor Lamps

  • LED Lamp Boards configuration

Pages: 11 teleCARE LED Lamp Boards User manual

Brand: teleCARE Category: Musical Equipment Size: 2 MB

Languages: English

Open manual

Frequently Answers and Questions

How do I connect the room bus cables to the IP Room Controller?

The room bus cables need to be connected to the 4-pole connector terminal (NICT-4AA), which is not included with the IP Room Controller and must be ordered separately. The connector terminal has four terminals with two connection points each, accepting one solid wire of maximum size 20 gauge (0.5mm²) (0.8mmØ).

What is the maximum load for the external corridor lamp outputs?

The external corridor lamp outputs have a maximum load of 60mA per connection.

How do I connect the 24Vdc power supply to the IP Room Controller?

The 24Vdc power supply can be connected to the 2-pole connector terminal (NICT-2BA), which is not included with the IP Room Controller and must be ordered separately. The terminal has two screw terminals, each accepting one wire (up to wire size 14 gauge (1.5mm²) (1.4mmØ) or two wires (each up to 18 gauge (1mm²) (1.15mmØ).

Can I use a Power over Ethernet (PoE) switch to power the NIRC3?

Yes, the NIRC3 can be powered directly from a PoE 802.3af or 802.3at switch. Alternatively, you can use an external 24V DC power supply.

Where can I find information on connecting the LED lamp boards?

Details on connecting the LED lamp boards are given in section 5.6, LED Lamp boards, page 43.

How do I install the transceiver piggyback module (NIRX)?

Details on how to install the transceiver piggyback module (NIRX) are given in section "NIRX teleCARE IP Transceiver" on page 172.

advertisement