Metra Electronics 997416 Vehicle Audio & Video Installation User manual

REV. 07-29-09

KIT FEATURES

DIN head unit provisions

CD jewel case pocket (holds 2 jewel cases)

99-7416

INSTALLATION

INSTRUCTIONS

KIT COMPONENTS

Radio Housing

APPLICATIONS

CAR PAGE

NISSAN

Maxima 2000-03*................................1-2

* This kit fits the Bose and Comfort & Convenience packages.

(2) #8 x ½" Phillips Truss-

Head Screws

TOOLS REQUIRED

Phillips screwdriver

Hammer

WIRING AND ANTENNA CONNECTIONS (Sold Separately)

Harness:

• 70-7550 - Nissan harness 95-up

• 70-7551 - Nissan amp interface harness 95-up

Antenna Adapter:

• 40-NI10 - Nissan antenna adapter 87-08

K NOWLEDGE IS P OWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry.

Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow.

1-800-221-0932 www.metraonline.com

© COPYRIGHT 2001-09 METRA ELECTRONICS CORPORATION

1

ALL VEHICLES

3

Disconnect the negative battery terminal to prevent an accidental short circuit. Pull out on the climate control trim bezel and remove. Remove (2) Phillips screws exposed at the top of the factory bracket assembly. Remove the ashtray and (1) Phillips screw exposed in the ashtray cavity. Pull up on the gear shifter trim and remove. Unclip the lower dash trim bezel and remove. Remove (2) Phillips screws exposed at the bottom of the factory bracket assembly and remove the assembly from the sub-dash. Remove (8) Phillips screws securing the factory head unit to the bracket assembly and remove the unit.

2

"A"

"A"

1

Using a hammer, flatten the protruding screw holes ("A") on the factory brackets.

Mount the Radio Housing to the factory brackets with (2) #8 x ½" Phillips Truss-Head

Screws supplied. Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure.

4 5

A

C

B

D

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).

Re-connect the battery terminal and test the unit for proper operation. Mount the factory bracket assembly to the sub-dash with (4) Phillips screws previously removed in step #1.

2