advertisement
◉
Touch to zoom
INSTALLATION INSTRUCTIONS (Rev. 11/28/2003). WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER, Il ASSEMBLING THE FIXTURE (Fig. 1) 1. Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration. 2. Shut off power at the circuit breaker and remove old fixture including the crossbar. 3. Place Shade (B) upwards against Light Assembly (A) followed by Washer (C) and secure with Screw Shell (D). HANGING THE FIXTURE (Fig. 2) 4. Thread Nipple into Loop until snug. Fig. 1 AIS, Ь —] a] © 5. Thread other end of Nipple with Loop attached into crossbar until snug. 6. Place Lock Washer over end of Nipple protruding through crossbar and thread Hex Nut onto nipple until tight. 7. Take this crossbar assembly and mount to ceiling junction box with junction box screws. Tighten screws securely with screwdriver. 8. By measuring determine correct number of links needed for proper hanging height. 9. Use a pair of pliers to open one end link of the chain, attach the chain to the fixture’s loop, close the link. Slip Leop Collar and Canopy over the chain. 10. Open the other end link of the chain and lift the fixture to attach to the ceiling loop, close the chain link. 11. Lace the fixture’s wires through the chain links and pull until taut. Feed the fixture wires through the Loop and Nipple and pull until taut. CONNECTING THE WIRES (Fig. 3) 12. At this point, connect the electrical wire as shown in Fig. 2 Junction Box (Ceiling) Hex Nut Lock Washer Canopy Loop Collar figure 3, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixture's Ground Wire to it. Otherwise, connect the fixture's Ground Wire directly to the crossbar using the Green Screw provided. 13. Tuck these wire connections neatly into the ceiling junction box and then raise the canopy all the way to the ceiling. Raise the Lock Collar and thread onto ceiling Loop protruding through Canopy. 14. Install the light bulbs in accordance with the fixture’s Fig. 3 FIXTURE C > FIXTURE WIRES WIRES Black or White or Smooth Ribbed 0 0 FIXTURE WIRES Bara opper (Ground) HOUSE WIRES ite (Green (Neutral) (Ground) specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!) Your installation is now complete. Return power to the junction box and test the fixture. Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased. LA-645E LJ american lighting, association
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project