Kenroy Home 21389ORB Assembly Instructions

 MODEL: 21389
PACKING DIAGRAM
~~ .CA TITLE 20
| CARDBOARD
SOCKET ASSEMBLY, FINIAL,
POLE (8 4 STEM AND RUBBER WASHER.
STYROFOAM: 12 KGS.
©
FINIAL
RUBBER
WASHER
—“*—— | — SHADE
21 389SHORB
(REPLACEMENT
PART)
SOCKET
oT
METAL
FRAM
LEVELING FEET
(2 PCS)
PLASTIC FEET
(2 PCS)
TEM
OCKET (2 PCS)
ULL CHAIN
SWITCH
AVAILABLE PART
21389SHORB (SHADE)
IS:
(4 PCS)
PPER TUBE
07/2014
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
UNPACK THE LAMP
YOU SHOULD HAVE RECEIVED THE FOLLOWING PARTS IN THE
PACKAGE: FINIAL, RUBBER WASHER, STEM, SHADE, SOCKET
ASSEMBLY, METAL FRAME, (4) MIDDLE TUBES AND (4) LOWER
TUBES. TO PROTECT THE FINISH, PLACE ALL PARTS ON A
SOFT SURFACE.
ASSEMBLE THE LAMP
1. CAREFULLY ORGANIZE AND PLACE ALL PARTS ON A
SMOOTH, FLAT SURFACE. LINE UP ALL OF THE PARTS
ACCORDING TO THE ASSEMBLY DIAGRAM.
2. SCREW SOCKET ASSEMBLY TO TOP OF THE METAL FRAME.
3. SCREW (4) UPPER TUBES TO BOTTOM OF METAL FRAME.
4, SCREW (4) LOWER TUBES TO BOTTOM OF UPPER TUBES.
5. SCREW SOCKET ASSEMBLY TO TOP OF SOCKET ASSEMBLY.
6. PLACE SHADE ONTO STEM, THEN SECURE WITH RUBBER
WASHER AND FINIAL.
7. INSTALL A 150 WATT MAXIMUM MEDIUM BASE TYPE "A"
BULB (NOT INCLUDED) INTO EACH SOCKET.
8. ADJUST LEVELING FEET ON BOTTOM OF LOWER TUBES TO
MAKE SURE THE LAMP SITS LEVEL ON THE FLOOR.
9. PLUG THE POWER CORD INTO AN OUTLET AND TURN ON
THE LAMP BY PULLING PULL CHAIN SWITCH.
BULB REPLACEMENT
1. BEFORE REPLACING THE BULB, BE SURE THAT THE SHADE
AND BULB ARE COOL AND LAMP IS UNPLUGGED.
2. UNSCREW EXISTING BULB FROM SOCKET AND REPLACE
WITH A NEW BULB. PLUG POWER SUPPLY CORD BACK INTO
OUTLET.
TROUBLE SHOOTING
1. IF YOUR LAMP DOES NOT LIGHT, CHECK PLUG AT THE
OUTLET. MAKE SURE THE PLUG IS FULLY AND PROPERLY
INSERTED INTO THE POWER OUTLET.
2. IF LAMP STILL DOES NOT LIGHT, UNPLUG FROM OUTLET.
CHECK THE BULB FOR A BROKEN FILAMENT. REPLACE BULB
IF NECESSARY, PLUG IN LAMP AND TURN IT ON.
3. IF THE LAMP STILL DOES NOT LIGHT, PLEASE CONTACT
YOUR DISTRIBUTOR OR PLACE OF PURCHASE.
IMPORTANT SAFETY INSTRUCTIONS
THIS PORTABLE LAMP HAS A POLARIZED PLUG (ONE BLADE
IS WIDER THAN THE OTHER) AS A FEATURE TO REDUCE THE
RISK OF ELECTRIC SHOCK. THIS PLUG WILL FIT IN A
POLARIZED OUTLET ONLY ONE WAY. IF THE PLUG DOES NOT
FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL
DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. NEVER
USE WITH AN EXTENSION CORD UNLESS PLUG CAN BE FULLY
INSERTED. DO NOT ALTER THE PLUG.
213890RB INSTRUCTIONS