Vacuum Cleaner

user manual

✻ Before operating this unit, please read the instructions carefully.

✻ For indoor use only.

imagine the possibilities

Thank you for purchasing a Samsung product.

To receive a more complete service, please register your product at

www.samsung.com/register

English

safety information

SAFETY INFORMATION

WARNING

• Before operating the appliance, please read this manual thoroughly and retain it for your reference.

WARNING

• Because these following operating instructions cover various models, the characteristics of your vacuum cleaner may differ slightly from those described in this manual.

CAUTION/WARNING SYMBOLS USED

WARNING

Indicates that a danger of death or serious injury exists.

Indicates that a risk of personal injury or material damage exists.

CAUTION

OTHER SYMBOLS USED

Represents something you must NOT do.

Represents something you must follow.

Indicates that you must disconnect the power plug from the socket.

02_ safety information

safety information

IMPORTANT SAFEGUARDS

1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner.

2. WARNING : Do not use the vacuum cleaner when rug or fl oor is wet.

Do not use to suck up water.

3. Do not use the vacuum cleaner without a dust bin.

Empty the dust bin before it is full in order to maintain the best effi ciency.

4. Slide to the Stop(or Min)position before inserting a plug into the electrical outlet.

5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts.

Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour the plastic parts of the unit.

6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose.

Do not block the suction or the exhaust port.

7. Switch the vacuum cleaner off on the body of the machine before unplugging from the electrical outlet. Disconnect the plug from the electrical outlet before changing the dust bag or dust container. To avoid damage, please remove the plug by grasping the plug itself, not by pulling on the cord.

8. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

9. Children should be supervised to ensure that they do not play with the appliance.

10. The plug must be removed from the socket outlet before cleaning or maintaining the appliance.

11. The use of an extension cord is not recommended.

12. If your vacuum cleaner is not operating correctly, switch off the power supply and consult an authorized service agent.

13. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualifi ed person in order to avoid a hazard.

14. Don’t carry the vacuum cleaner by holding the hose.

Use the handle on the vacuum cleaner set.

15. Unplug the cleaner when not in use. Turn off the power switch before unplugging.

safety information _03

contents

ASSEMBLING THE CLEANER

05

OPERATING THE CLEANER

06

07 Power-Control

MAINTAIN TOOLS AND FILTER

08

09 Maintain fl oor tools

11 Emptying the dust bin

12 When to clean the dust pack

13 Cleaning the dust pack

14 Cleaning the motor protection fi lter

14 Cleaning the outlet fi lter

15 Change the battery (option)

TROUBLESHOOTING

16

04_ contents

assembling the cleaner

OPTION

• Features may vary according to model.

• Please do not press the button of dust bin handle when carrying machine.

• For storage, park the fl oor nozzle.

OPTION assembling _05

operating the cleaner

ON/OFF SWITCH

1) BODY CONTROL

TYPE

2) ON/OFF TYPE 3) HANDLE CONTROL

TYPE

CAUTION

• When removing the plug from the electrical outlet, grasp the plug, not the cord.

POWER CORD

06_ operating

POWER-CONTROL

BODY-CONTROL TYPE / ON/OFF TYPE

• HOSE

To reduce suction for cleaning draperies, small rugs, and other light fabrics, pull the tap air until the hole is open.

• BODY (BODY-CONTROL TYPE ONLY)

MIN = For delicate surface e.g. net curtains.

MAX = For hard fl oors and heavily soiled carpets.

HANDLE CONTROL TYPE

• HOSE

Vacuum cleaner MODE (MIN/MID,MAX)

Press the MODE button repeatedly to select the correct mode.

(ON) MIN → MID → MAX

Handle Control

The cleaner is controlled by using infrared signals.

operating _07

maintain tools and fi lter

USING ACCESSORY

Pipe (Option)

• Adjust the length of the telescopic pipe by sliding the length control button located in the center of the telescopic pipe back and forth.

• To check for blockages, separate the telescopic pipe and adjust to shorten. This allows for easier removal of waste clogging the tube.

Accessory

• Dusting brush for furniture. shelves, books, etc.

• Crevice tool for radiators, crevices, corners, between cushions.

08_ maintain

MAINTAIN FLOOR TOOLS

2-Step Brush (Option)

• Adjust the inlet lever according to the fl oor surface.

• Remove waste matter completely if the inlet is blocked.

Pet Brush (Option)

For improved pick-up of pet hair and fi bre on carpets.

Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum. In this case, clean the drum with care.

Blanket brush (Option)

Clogs on turbine keep brush from turning, thus need to be unclogged as follows. For picking up pet hair and fi bre on upholstery and bed linen.

Remove waste matter completely when inlet is blocked.

Turn the lock button to ‘UNLOCK’, and remove waste matter.

To reassemble, align the cover to the front of the main body and close. After closing the cover, ensure that the lock button is turned to the ‘LOCK’ position.

WARNING

Use for bedclothes only. Be cautious not to damage brush during unclogging.

maintain _09

maintain tools and fi lter

Mini turbo brush (Optional)

- TO REPLACE BRUSHROLL

1. If a clog is present or debris is visible, unscrew the two screws on the back of the Mini turbo brush to remove the faceplate and clear any obstructions.

2. Inspect condition of brushroll.

Replace brushroll if brushes are worn down.

To remove brushroll, pull up and out of end slots in nozzle housing.

Insert ends of brushroll into same slots to replace.

Inspect belt to ensure that it is in good condition.

If belt is broken or cracked, replace belt according to To Replace Belt instructions.

3. Using at MAX.

Press the MAX button to operate the vacuum at maximum intake.

- TO REPLACE BELT

1. Remove bottom plate.

See fi gure in To Replace Brushroll instructions.

2. Loop one end of new belt around shaft of pulley.

3. Loop other end of belt around designated area for it on brushroll. Insert brushroll into slots in nozzle housing.

See fi gure in To Replace Brushroll instructions.

4. Fit Mini turbo brush back together as described in

To Replace Brushroll instructions.

10_ maintain

EMPTYING THE DUST BIN

1. Once dust reaches the dust full mark, or sution

2. Take the dust bin out by pressing the button.

is noticeably reduced during cleaning, empty the dust bin.

3. Separate the dust bin cover.

4. Throw away dust into the bin.

5. Close the dust bin cover.

6. Before use, push the dust bin into the main body of the vacuum cleaner until you hear the “click” sound.

- Empty into a plastic bag

(recommended for asthma/ allergy sufferers)

You may rinse the dust bin with cold water.

maintain _11

maintain tools and fi lter

WHEN TO CLEAN THE DUST PACK

- If suction is noticeably reduced during cleaning, please check the dust pack as indicated below.

Turn the vacuum power to ‘MAX’.

If suction is noticeably reduced with the inlet fl oating 10cm above fl at fl oor, clean it.

When suction is noticeably reduced continuously, please cleaning the Dust Pack as shown in the following illustration.

12_ maintain

CLEANING THE DUST PACK

1. Remove the dust bin and dust pack as shown.

2. Remove the sponge and fi lter from the dust pack.

3. Wash the sponge and the fi lter of the dust pack with water.

4. Let the sponge and fi lter dry in the shade for more than 12 hours.

5. Put the sponge and fi lter into the dust pack.

6. Put the assembled dust pack into the main body.

Make sure the fi lter is completely dry before putting it back into the vacuum cleaner. Allow 12 hours for it to dry.

maintain _13

maintain tools and fi lter

CLEANING THE MOTOR PROTECTION FILTER

Take out both the dust bin and the dust pack.

Remove the motor protection fi lter from the vacuum cleaner.

Shake and tap the dust from it and put back in machine.

CLEANING THE OUTLET FILTER

OPTION - MICRO FILTER

Press the fi xed frame part at the back of the main body to remove.

Remove and replace the blocked outlet fi lter.

Replacement fi lters are available at your local

Samsung distributor.

OPTION

14_ maintain

CHANGE THE BATTERY (OPTION)

1. When the vacuum cleaner dows not work, replace the batteries. If the problem persists, please contact our authorized dealer.

2. Use 2 batteries of size AA.

WARNING

1. Never disassemble or recharge the batteries.

2. Never heat up the batteries or throw them into fi re.

3. Do not reverse (+), (-) poles

4. Dispose of the batteries property.

Size maintain _15

troubleshooting

PROBLEM SOLUTION

Motor dows not start.

• Check cable, pulg and socket.

• Leave to cool.

Suction force is gradually decreasing.

Body overheating

Static electicity discharge

• Check for blockage and remove.

Cord does not rewind fully.

• Pull the cord out 2-3m and push down the cord rewind button.

Vacuum cleaner dows not pick up dirt.

• Check hose and replace if required.

Low or decreasing suction

• Please check fi lter and, if required, clean as illustrated in the instructions. if fi lters are out of condition change them to new ones.

• Please check fi lters, If required clean as illustrated in the instruction.

• Please decrease power suction.

This Vacuum cleaner is approved the following.

EMC Directive : 2004/108/EEC

Low Voltage Directive : 2006/95/EC

If you have any questions or comments relating to Samsung products, please contact the

SAMSUNG customer care center.

COUNTRY

U.K

SOUTH AFRICA

CUSTOMER CARE CENTER

0330 SAMSUNG (7267864)

0860 7267864 (SAMSUNG)

WEB SITE www.samsung.com

www.samsung.com

Code No. DJ68-00532U REV(0.1)