Durkopp Adler 805 Installation Instructions

Part 2: Installation
1. Removing the transport safety
devices
Remove the transport safety devices from both
transfer carriages, the sewing head and the folding
device.
2. Balancing out the sewing unit
Lay ue spirit level on the stand and balance out
the sewing unit with the 4 feet 1 accordingly. Make
sure that the weight is distributed almost evenly
among the 4 feet.
3. Mounting all components
— When mounting the stacker, its lateral position
needs to be adjusted. See subject 7.3 of the
service manual.
— Should the sewing unit include a milling device,
the vacuum unit 6 needs to be mounted as well.
To do this, connect its plug with the socket
under the table top. Insert the hose 4 into the
connection piece 3 on the machine.
4. Connecting the sewing unit
electrically and pneumatically
— Connect the hose of the sewing unit to the N
compressed air line (7 - 10 bar). 48
— Connect the plug of the sewing unit with the
mains. Make sure that the machine is only
operated with the voltage specified on the
name plate.
5. Calling up the "Automatic" menu
— Turn on the machine and zero the carriages,
see subject 3.1 of the operation manual.
— Read the code and call up the "Automatic"
menu, see subject 3.2 of the operation manual.
To select another on-screen
language:
Call up the "Service" menu using the menu key.
Call up the menu "Service technician”, see 9.1
of the service manual.
Select the "Language" menu using the key 9.
Select the desired language with the correspon-
ding key.
Call up again the menu "Service technician”.
Checking the functions of the entire
sewing unit
Call up the "Automatic" menu using the menu
key.
Select a speed of approx. 30% using the
key —.
Enter "Folding control”.
Load the cut pieces and activate the folding
process (see subject 3.4 of the operation
manual).
Proceed with the automatic sequence using
the key "1".
Check the set pocket.