ITB11-064b

BT11-035b ITB11-064b 25,

SQUEAK NOISE WHEN PRESSING ACCELERATOR PEDAL

This bulletin has been amended to include a parts information table only. No other changes have been made to the body of this bulletin.

APPLIED VEHICLES: 2007 - 2012 G37 Sedan (V36)

2008 - 2012 G37 Coupe (CV36)

2009 - 2012 G37 Convertible (HV36)

2011 - 2012 G25 Sedan (V36)

2008 - 2012 EX35 (J50)

2011 - 2012 M (Y51)

IF YOU CONFIRM:

The Accelerator Pedal squeaks when being pressed.

ACTION:

Apply urethane foam pad, from Squeak and Rattle Kit, between the upper Accelerator Pedal Bracket and the

Accelerator Pedal Assembly.

• See steps on next page to apply foam.

NOTE: Refer to Electronic Service Manual (ESM) for procedure to remove and reinstall Accelerator Pedal

Assembly, and for Accelerator Pedal Released Position Learning.

PARTS INFORMATION

DESCRIPTION PART # QUANTITY

Urethane Pad

CLAIMS INFORMATION

76884-71L02

Submit a Primary Part (PP) line claim using the following claims coding:

1

DESCRIPTION PFP SYM

Install Foam on Accelerator Pedal Bracket (1) FX44AA ZL 44 0.2

(1) Refer to the electronic parts catalog (FAST or equivalent) and use the appropriate Accelerator Pedal

Assembly part number as the primary part.

Infiniti Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO NOT assume that it does. See your Infiniti dealer to determine if this applies to your vehicle.

1/4

Confirm that engine and ignition are off

1. Remove Accelerator Pedal Assembly.

• Figure 2 shown with Accelerator Pedal removed, and bracket circled in green.

Figure 1

¾ Pedal removed.

Figure 2

Figure 2

2. Attach piece of 1.5 by 2.0 inch foam, from “Squeak and Rattle Kit”, to backside of Accelerator Assembly

Bracket, with adhesive facing outward.

• 2.0” x 1.5” precut urethane foam. Part number (76884-71L02).

Figure 3

2/4 ITB11-064b

3. Figure 4 shows foam attached to backside of bracket.

Figure 4

4. Side view of foam attached to backside of bracket.

5. Fold foam over and stick to front side of bracket.

Figure 5

Figure 6

3/4 ITB11-064b

6. Re-install Accelerator Pedal over bracket with foam installed.

Figure 7

7. Refer to ESM for Accelerator Pedal Self Learn Procedure.

8. After installing Accelerator Pedal Assembly over foam, confirm that the squeak noise is gone.

4/4 ITB11-064b