advertisement
◉
Touch to zoom
Mini 2 Pin Strip to Strip Clamp Connector ledworldlighting.com | ledworld.ca Model: CL10BB-2 1-800-387-4081 CAUTION: Max 5 Amps 12/24VDC (low voltage). Use only with Class 2 power supply. Max 120 LEDs/Meter. Indoor dry location use. ATTENTION: Utiliser seulement avec la classe 2 bloc d’alimentation. For use only with LED World’s type A (IP20) 12VDC and 24VDC 10mm wide LED Flex Strips. Not to be used with Type B or C (Strips that have covers or coatings). IMPORTANT NOTE: Check the Polarity and make sure that connector contact points are directly over (and centered) the LED Flex Strip connector pads. Do not connect LED strips at soldered contact points. - To + + - + To + + - + - CORRECT + WRONG INSTALLATION STEPS 2 1 Cut the LED Strips at the cut mark (pads) Remove the wax paper from back of the LED Strips 3 4 Push both LED Strips into contact points over pads. Close the cap gently Complete the LED Strip connection using plyers. Make sure connection is locked at base of connector 5 Test Connection LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.0 - 10/28/2019 Copyright @2019 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and speciļcations subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
advertisement
Related manuals
advertisement