advertisement
◉
Touch to zoom
2 Pin Strip to Power Clear Connector ledworldlighting.com | ledworld.ca Model: BCI10XB-2W 1-800-387-4081 CAUTION: Max 5 Amps 12/24VDC (low voltage). Use only with 20 or 22 AWG UL/CSA wire. Use only with Class 2 power supply. Max 120 LEDs/Meter. Indoor dry location use. ATTENTION: Utiliser seulement avec la classe 2 bloc d’alimentation. For use only with LED World’s type A 12VDC and 24VDC 10mm wide LED Flex Strips. Not to be used with Type B or C (Strips that have covers or coatings). Important Note: Check the Polarity and make sure that connector contact points are directly over (and centered) the LED Flex Strip connector pads. Do not connect LED strips at soldered contact points. + To + - To + + - V+ + - V- CORRECT V- V+ WRONG INSTALLATION STEPS 2 1 Cut the LED Strip at the cut mark (pads) 3 Remove the wax paper from back of the LED Strip Push the LED Strip into contact points over pads 4 5 6 Make sure that strip is inserted all the way in. (Note: There might be slight gap between strip and connector) Complete the connection using plyers. Make sure cap is locked at base of connector Test Connection. Wiggle gently. LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.0 - 11/17/2020 Copyright @2020 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and speciļcations subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
advertisement
Related manuals
advertisement