Craftex CT103N BANDSAW 18" 2HP CAST IRON WHEELS CSA Owner Manual

CHANGING SPEEDS for CT103N

The motor has a 3-step pulley which will give you the 3 feed-speeds. The belt tension is adjusted by loosening the nut “A” (see figure-1), and the motor bracket lock “B” under the motor (see figure-1) and moving the motor slightly.

Figure-1 Shows the Nuts and the Motor Bracket Lock

Idler pulley is a 4-step pulley “C” (see figure-2). The 3 steps are to line up with the motor pulley for the 3 feed-speeds and the 4 th

one is to drive the pulley behind the wheel. The idler pulley can be adjusted by loosening the nut “D” (see figure-1) at the back of the machine and adjusting it.

Figure- 2 Shows the Pulleys and the Wheel Inside the Cabinet