Manual for Nobels Footswitch FS-2L

Owners Manual FS-2L

The FS-2L incorporates 2 ON/OFF-switches in one housing.

ON/OFF-switches (latch-type) are used in most amplifiers, e.g.for channel or reverb switching.

The FS-2L can be operated without any battery. When using a battery, the 2 LEDs will indicate the state of each switch:

Led "ON" = switch is closed

Led "OFF" = switch is open

NOTE: Please remove the battery, if you do not need the FS-

2L for a longer period of time.

-NOTE: The switches are not connected to each other, so you have no hum noise causing by a ground loop!

Using 1 stereo cable for 2 switching operation!

2 USING A STEREO CABLE:

You can easily connect a stereo cable between "Out-2 / Stereo" of the FS-2L and your favorit amp. Make sure that

"Out-1" is not plugged!

NOTE: Of course you also can use the

FS-2L as a single switch!

3 USING 2 SEPERATE MONO CABLES:

Ycan easily connect 2 mono cable from "Out-1" and "Out-2" of the FS-2L to 2 amps.

NOTE: The switches are not connected to each other, so you have no hum noise causing by a ground loop!

Owners Manual FS-2U

The FS-2U is a dual footswitch for almost all units on the market which needs remote control by a latched type switch. The versatility of this switch makes it comfortable for different connections.

This unlatched (momentary) switch type is often used by computer controlled devices, such as multieffects. Especially all NOBELS Effectpedals can be remote switched!

1 THE POLARITY SWITCHES

Two switches allows you to match the FS-2U to your equipment. If one or both switches are working "vice-versa" try to reverse the polarity by using the corresponding selector switch.

NOTE: Refer to the owners manual of the connected unit!

2 USING A STEREO CABLE:

You can easily connect a stereo cable between

"Out-2 / Stereo" of the FS-2U and your favorit pre-amp or effect device. Make sure that "Out-1" is not plugged!

NOTE: Of course you can also use the FS-2U as a single switch!

Using 1 stereo cable for 2 switching operation!

3 USING 2 SEPERATE MONO CABLES:

You can easily connect 2 mono cables from "Out-1" and "Out-2" of the FS-2U to 2 units.

NOTE: The switches are not connected to each other, so you have no hum noise causing by a ground loop!

No Ground connection between both Preamps!

Using 2 mono cables for 2 switching operation!

No Ground connection between both Preamps!

Using 2 mono cables for 2 switching operation!

KTA 980410-0234

If you need more information: Please ask your local dealer!