SuperH Family E10A-USB Emulator Supplementary Information on Using the SH7214 and SH7216 Additional Document for User's Manual

Table of Contents

Section 1 Connecting the Emulator with the User System .................................................................... 1

1.1

Components of the Emulator .................................................................................................................................... 1

1.2

Connecting the Emulator with the User System ....................................................................................................... 3

1.3

Installing the H-UDI Port Connector on the User System ........................................................................................ 4

1.4

Pin Assignments of the H-UDI Port Connector ........................................................................................................ 5

1.5

Recommended Circuit between the H-UDI Port Connector and the MCU .............................................................. 9

1.5.1

Recommended Circuit (36-Pin Type) ............................................................................................................ 9

1.5.2

Recommended Circuit (14-Pin Type) .......................................................................................................... 12

1.5.3

Recommended Circuit (38-Pin Type) .......................................................................................................... 14

Section 2 Software Specifications when Using the SH7214 and SH7216 Group ............................... 17

2.1

Differences between the MCU and the Emulator ................................................................................................... 17

2.2

Specific Functions for the Emulator when Using the SH7214 and SH7216 Group................................................ 25

2.2.1

Event Condition Functions ........................................................................................................................... 25

2.2.2

Trace Functions ............................................................................................................................................ 32

2.2.3

Note on Using the JTAG (H-UDI) Clock (TCK) ......................................................................................... 43

2.2.4

Notes on Setting the [Breakpoint] Dialog Box............................................................................................. 44

2.2.5

Notes on Setting the [Event Condition] Dialog Box and the BREAKCONDITION_ SET Command........ 45

2.2.6

Performance Measurement Function............................................................................................................ 45