Pull cord replacement. Weed Eater 31WG

Pull cord replacement

1.

Buy string/cord in same or slightly larger diameter.

2.

Take off plastic cover. You need a hex and a torx driver. Take of green housing. Also take off black handle.

3.

The spool is held by clips on a wheel at the bottom. Screws hold the clips tight, just loosen do not remove, turn clips and take out spool.

4.

Check path that the string follows, thread string and wrap the same way. Wind string until spool is full. Usually it is about a foot of string.

5.

Put string through housing and replace spool. Ensure it is seated properly.

6.

Ensure it is seated properly and replace screws.

7.

Ensure the trigger is in place to pull the throttle cable. Reattach handle with screws.

8.

Ensure the cord is turning the motor. Thread through pull cord handle and tie off, cut excess.

9.

Test start.

58