Installing the LTO Driver Software. Quantum LTO 1

LTO-3 Half-Height Tape Drive

5 Reconnect the workstation or server system AC power cord to the facility AC power receptacle.

After connecting the tabletop drive interface and AC power cables, proceed to

Restarting the Tabletop Tape Drive System in the following subsection.

Restarting the Tabletop

Tape Drive System 0

After connecting the tabletop drive interface and AC power cables:

1 Set the tabletop drive AC power switch to the on position.

2 Restart the workstation or server system.

3 Verify that the tabletop LTO-3 Half-Height Tape Drive comes on and completes the

Power On Self Test (POST) functions.

As required, proceed to either:

•

Installing the LTO Driver Software

•

Registering the LTO-3 Half-Height Tape Drive

Installing the LTO Driver Software

If you intend to use the LTO-3 Half-Height Tape Drive with the Microsoft applet on a Windows 2000, Windows Server ® 2003, Windows XP ®

® native backup

, or Windows Vista operating system, install the appropriate version of the LTO driver software. (See the

Downloads page for LTO-3 drivers under Standalone Tape Drives on the Quantum support website at: www.quantum.com/support .)

Note: The LTO driver software is not necessary with commercial backup application software.

Registering the LTO-3 Half-Height Tape Drive

After installing the LTO-3 Half-Height Tape Drive, be sure to register it via the Quantum website at: www.quantum.com/registration

Registering the drive ensures that you will receive the latest technical information about the drive, as well as other product, service, and support information.

Installing the LTO Driver Software 13