advertisement
Figure 1
SPECIFICATIONS
MODEL
Working Width
Moldboard Height
Box Depth
Overall Depth
Overall Height
Overall Width
Side Sheet Thick.
Scarifier Size
Scarifier Teeth
Hitch
Lower Hitch
Cutting Edge
Number of Blades
Approx. Weight
Tractor HP
BBC-48
48”
11-1/2”
12”
18-3/4”
26-1/4”
48-3/4”
1/4”
3/4” x 2-1/2”
4
Category 1
Cat 1 Pin
1/2” x 6”
BBC-60
60”
11-1/2”
12”
18-3/4”
26-1/4”
60-3/4”
1/4”
3/4” x 2-1/2”
5
Category 1
Cat 1 Pin
1/2” x 6”
2
248 lbs.
2
258 lbs.
24 (Maximum) 24 (Maximum)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Mast
Top Center Link
Mounting Position
Lower Lift Arm Pins
Scarifier Shank
SECTION I
OPERATION
WARNING
DURING BLADE ADJUSTMENT
KEEP BODY, HANDS AND FEET CLEAR
OF BLADE.
ATTACHMENT
The box blade should be placed on level ground.
NOTE: Hitch pins can be mounted extending toward the outside or center of the implement to
fit different tractor lift arms. Secure the lift arms to the pins. (Figure 1)
Attach the center link to the top of the mast and adjust so that the blade frame will be level in the operating position.
Place the tractor rockshaft control in “position control” (non-floating) for attaching and detaching the rear mounted blade. “Draft control” or “position control” can be used while operating.
DETACHING FROM TRACTOR
Back the tractor until the ends of the lift arms can be attached to the lift pins on the implement.
Lower the blade to the ground with rockshaft control in position control. Remove top link from mast, disconnect hitch arms from bottom pins and pull tractor away from blade.
6
advertisement
Related manuals
advertisement