advertisement
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes Personal vorgenommen werden.
Notice
Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made.
The hardware, firmware, or software described in this document is subject to change without notice.
IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR
CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF
OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN THEM, EVEN IF
ENTERASYS NETWORKS HAS BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN OF, THE POSSIBILITY OF
SUCH DAMAGES.
Enterasys Networks, Inc.
50 Minuteman Road
Andover, MA 01810
© 2006 Enterasys Networks, Inc. All rights reserved.
Part Number: 9034285‐01 November 2006
ENTERASYS, ENTERASYS NETWORKS, ENTERASYS ROAMABOUT, ROAMABOUT, ENTERASYS MATRIX, LANVIEW,
MATRIX, NETSIGHT, WEBVIEW, and any logos associated therewith, are trademarks or registered trademarks of
Enterasys Networks, Inc., in the United States and other countries.
All other product names mentioned in this manual may be trademarks or registered trademarks of their respective companies.
Documentation URL: http://www.enterasys.com/services/support
Documentacion URL: http://www.enterasys.com/services/support
Dokumentation im Internet: http://www.enterasys.com/services/support i
advertisement
Related manuals
advertisement
Table of contents
- 1 Title
- 3 Notice
- 4 Regulatory Compliance Information
- 11 Contents
- 13 About This Guide
- 13 Intended Audience
- 13 Associated Documents
- 13 Conventions Used in This Guide
- 14 Getting Help
- 15 RBT-8110 Wireless Switch Overview
- 15 Kit Contents
- 15 Front Panel Controls and Indicators
- 17 Chassis Back Panel
- 17 Power Supply
- 17 Physical Specifications
- 18 Environmental Specifications
- 19 Installation
- 19 Safety Information
- 22 Rack Mounting
- 22 Front Mount
- 23 Mid-Mount
- 25 Configuration
- 25 Pre-Configuration Tasks
- 25 Wireless Switch Configuration Tasks
- 25 Using the CLI quickstart Command
- 27 quickstart Command Procedure
- 29 Configuring RoamAbout Wireless Switches Using RASM
- 29 Preconfigure the Wireless Switch in RASM
- 30 Stage the Wireless Switch
- 33 Preparing the Network for Distributed Access Points
- 35 Index