Symbols. Ryobi SA60, SA720

SYMBOLS

Important: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer.

SYMBOL

V

A

Hz min

NAME

Volts

Amperes

Hertz

Minutes

Alternating Current

Direct Current

DESIGNATION/EXPLANATION

Voltage

Current

Frequency (cycles per second)

Time

Type or a characteristic of current

Type or a characteristic of current --n

0

No Load Speed

.../min Revolutions or Reciprocation Per Minute

Safety Alert Symbol

Wear Eye Protection

Wet Conditions Alert

Rotational speed, at no load

Revolutions, strokes, surface speed, orbits etc. per minute

Indicates danger, warning or caution.

It means attention!!! Your safety is involved.

Always wear safety goggles or safety glasses with side shields when operating this product.

Do not expose to rain or use in damp locations.

The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and the explanations with them, deserve your careful attention and understanding. The safety warnings do not by themselves eliminate any danger. The instructions or warnings they give are not substitutes for proper accident prevention measures.

Symbol Meaning

DANGER:

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

NOTE:

WARNING:

Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

CAUTION:

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices that may cause property damage.

Advises you of information or instructions vital to the operation or maintenance of the equipment.

Page 6