Electronics. Datexx DS-700

Add to My manuals

advertisement

Electronics. Datexx DS-700 | Manualzz

PARALLEL RESISTANCE

Three resistors are connected in parallel. Their values are 540 ohms, 470 ohms and 680 ohms.

Calculate the total equivalent resistance.

Req = 1

1 + 1 + 1

R1 R2 R3

Req = 1

1 + 1 + 1

680 470 540

Press

680 [2ndF] [1/x ] [+]

470 [2ndF] [1/x ] [+]

540 [2ndF] [1/x ] [=]

[1/x ]

Display

0.001470588

0.003598247

0.005450 100

183.4828833

CARE AND MAINTENANCE

Attempting to modify or tamper with the caclulator’s interal components can cause a malfunction and invalidate the warranty.

32

REPLACING THE BATTERIES

This calculator is powered by two internal batteries LR 44 or A76. If the display gets dim or calculations slow down the batteries should be replaced.

To replace the batteries:

1.Remove the six screws on the back of the calculator and lift off the back cover.

2.Replace the two batteries located near the tip of the calculator with new batteries following the polarity shown in the illustration.

3.Replace the back cover and screws.

BATTERY PRECAUTIONS

1.Only use the size and type of batteries specified.

2.Follow the correct polarity when installing the batteries. Reversed batteries can cause damage to the calculator.

3.If the calculator is not going to be used for a long period of time, remove the batteries to prevent the damage or injury from possible battery leakage.

33

advertisement

Key Features

  • Binary-Octal-Hexadecimal-Decimal conversion
  • Built-in Random Number Generator
  • Built-in Trigonometric and Algebraic Functions
  • Display Format: Floating point and Scientific notation
  • Hyperbolic and Inverse Hyperbolic functions
  • Two Factor Operations
  • Trigonometric Calculations in Degrees, Radians, and Grads
  • Statistical calculations mode

Related manuals

Frequently Answers and Questions

How do I change the display format?
Press the TAB key to change the display format between floating point and scientific notation.
How do I use the statistical calculations mode?
Press the Power on and clear / statistical calculation mode key to activate the statistical program. The display will be cleared, and STAT will appear in the display.
How do I change the angular mode?
Press the Degree / Radian / Grad selector / angular unit conversion key (DRG) to change the angular mode between degrees, radians, and grads.
How do I calculate the factorial of a number?
Press the Clear Entry / Factorial key after entering the number.
How do I convert between decimal degrees and degrees / minutes / seconds?
Press the Decimal degrees conversion / Hexadecimal number key (ƒ) to convert between decimal degrees and degrees / minutes / seconds.