advertisement
Chapter 4. Use Front USB Backup Button
By connecting an external storage device to the NAS, you can use the front USB backup button to copy data from the external device to NAS or from the NAS to the external device. To use this function, please follow the steps below:
1. Make sure a SATA disk is installed correctly in the NAS according to the instructions
2. Turn on the NAS.
3. Go to System Tools/ USB one touch copy backup to configure the settings.
4. Connect USB devices, e.g. digital camera, flash, external USB drive to the front USB port of the NAS.
5. Press the Copy button on the NAS. The data is copied according to your settings in
System Tools/ USB one touch copy backup.
# Intelligent one touch copy button: The NAS detects the data in the connected source automatically. The first time a USB device is connected, press the Copy button and the
NAS copies all data in the device automatically. When the same device is connected again and there are changes to the source data, press the Copy button, and the NAS copies all files in the device. If there are no changes, press the Copy button and the
NAS does not copy the files.
Intelligent one touch copy button
121
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project