<b>SAFETY INSTRUCTIONS FOR INSTALLATION </b>. Miele CSGP 1400, CS 1322

SAFETY INSTRUCTIONS FOR INSTALLATION

Note to the installer:

Please leave this instruction book with the consumer for the local electrical inspector’s use.

The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire.

The cabinetry and venting hood should be installed first to prevent damage to the appliance.

~

The countertop must be bonded with heat resistant (212 °F/100 °C) adhesive to prevent distortion or dissolving.

The wall strips must be heat-resistant as well.

~

To eliminate the risk of burns or fire by reaching over heated surfaces cabinet storage space above the appliance should be avoided. If cabinet storage is necessary, the risk can be reduced by installing a venting hood to project horizontally a minimum of 5"

(127 mm) beyond the bottom of the cabinets.

~

This appliance has not been designed for maritime use or for use in mobile installations such as recreational vehicles or aircraft. However, under certain conditions it may be possible for installation in these applications. Please contact the Miele Technical Service

Department with specific requirements.

~

The grill must not be installed directly next to the CS 1421

(Salamander). It is essential to maintain a distance of at least 5 7 /

8

" (150 mm) between these two appliances.

~

You must ensure the power cable for the appliance will not come under any mechanical strain once installed e.g., while the water is draining.

~

Be sure that after installation the power cord does not come into contact with any parts of the appliance which may become hot.

~

The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. See

"Sealing".

Keep this instruction book in a safe place for reference and pass it on to any future user.

20

SAFETY INSTRUCTIONS FOR INSTALLATION

Safety distances above the appliance

If there is more than one appliance beneath a hood (e.g. wok burner and electric grill), and they have different minimum safety distances always observe the greater distance.

The minimum safety distance given by the hood manufacturer must be maintained between the grill and the hood above it. See the installation instructions of the hood for these safety measurements.

If the hood manufacturers instructions are not available or if flammable objects are installed over the grill (e.g.

cabinets, utensil rail, etc.), a minimum safety distance of 30" (760 mm) must be maintained.

21

SAFETY INSTRUCTIONS FOR INSTALLATION

Safety distances to the sides of the appliance

The appliance should only be installed as shown in the illustrations while maintaining the required safety distances shown. Do not install the appliance between two tall cabinets, this is a fire hazard.

A distance of at least 2" (50 mm) must be kept between the countertop cut-out and the rear wall because of the high temperatures radiated.

The minimum distance a between the worktop cut-out and a wall or tall unit to the right or left of it is:

2" (50 mm) for CS 1112

CS 1122

CS 1212

CS 1221

CS 1223

CS 1326

CS 1411

6" (150 mm) for CS 1312

CS 1322

CS 1421

10" (250 mm) for CS 1011

CS 1012

CS 1028 recommended

2"

(50mm)

2 " (50 mm)

1 not recommended not permitted

22