To enable Parallel Broadband. Compex Technologies WPE54, WPE54G, Network Card WPE54

Chapter 5 Further Configuration

5.7.3 To enable Parallel Broadband

Before enabling the Parallel Broadband feature, verify whether:

•

Each of the access points is correctly configured to connect to its specific broadband Internet account.

•

You need to enable DHCP on all of the access points in Parallel broadband. It is recommended that each of the access points leases IP in a non-overlapping IP address pool.

•

All of the access points are interconnected in a chain manner using WDS as illustrated in the section on WLAN Basic Setup.

•

Each of the access points is running in Gateway mode with the Parallel

Broadband option enabled.

Enable Parallel Broadband

Click on Parallel Broadband from the CONFIGURATION menu.

By default the Parallel

Broadband feature is disabled.

Enable the Parallel Broadband

Status.

Click on Apply button.

Repeat this for the other access points in your network.

107