A Guided Tour. Cooper Security i-onEX

FOB-2W-4B

2. Lift off the battery lid.

3. Fit the new battery. The positive side of the battery should be on top. Note: make sure your hands are clean and dry when handling the battery. Even small amounts of grease or dirt can affect the contact between the battery and the fob.

4. Re-fit the battery lid.

5. Hold the key-ring shackle in place and re-fit the screw you removed in step 1.

6. Tighten the screw until it holds the battery lid closed. Do not over-tighten the screw.

7. Test the new battery by holding down the Query button on the fob for three seconds (see figure 2). You should see the red LED by that button flashing.

A Guided Tour

When you receive your fob for the first time, take a minute to look at it and identify each of the buttons. Figure 2 shows you where they are.

Set button Unset button

Set LED

Query LED

Unset LED

Part set LED

Query button Part Set button

(or programmable)

Figure 2.

Page 2