2D. Attach the seat with the seat belt. Razor Ground Force, 300001-SL, Ground Force 300001-SL

❏ 2 D. Optional attaching the seat with seat belt assembly.

Locate the four (4) long seat attachment screw and seat-belt assembly in the parts bag. Position the seat over the frame and align it with the holes in the frame. Position the seat-belt anchors with the lap/shoulder assembly on the left side and the receiver latch on right side. Insert the screws as shown in Figure 5a and tighten. Install the shoulder belt anchor to the back of the seat as shown in Figure 5b using the supplied screw, tighten securely.

Figure 5a Figure 5b

WARNING: The seat belt arrangement suppled with the Ground Force is for “play” use only. It is not an ASTM-approved safety belt system and is not intended to function as an approved lap/shoulder/seat restraining device. The seat belt system is not required for normal use. Install and use at your own risk.

NOTE: Although we make every effort to keep our manual up-to-date, if your

Ground Force does not look exactly as shown here, then we may have made improvements since this document was printed. Check out the Razor website: www.razor.com for technical updates on the latest service and adjustment procedures.

❏ 2 E. The brake. The Ground Force is fitted with a hand-operated brake. To use the brake, squeeze the lever to increase the pressure on the brake until so you come to a smooth and controlled stop. The brake lever is fitted with cable adjuster to compensate for cable stretch and/or to fine tune the lever movement to brake engagement. To adjust the play, thread the adjuster in or out (arrows, Figure 6a) 1/4 to 1/2 turn until the desired brake adjustment is attained.