Configuration (Standalone). Venue Lighting Effects thinpar 64

Configuration

(Standalone)

Sound-Active

Mode

Set the product in one of the standalone modes to control without a DMX controller.

1. Connect the product to a suitable power outlet.

2. Turn the product on.

Never connect a product that is operating in any standalone mode (either Static,

Automatic, or Sound) to a DMX string connected to a DMX controller. Products in standalone mode may transmit DMX signals that could interfere with the DMX signals from the controller.

To enable the Sound-Active mode, do the following:

1. Press <MENU> repeatedly until P-- shows on the display.

2. Use <UP> and <DOWN> to select P 5 or P 6.

3. Press <ENTER>.

4. Turn the music on and adjust the microphone sensitivity knob until the product starts responding to the beat of the music.

The product will only respond to low frequencies of music (bass and drums).

Automatic Mode

To enable the Automatic mode, follow the instructions below:

1. Press <MENU> repeatedly until P-- shows on the display.

2. Use <UP> and <DOWN> to select P 1~P 4.

3. Press <ENTER>.

Master/Slave

Mode

The Master/Slave mode allows a single SlimPAR™ 64 RGBA (the “master”) to control the actions of one or more SlimPAR™ 64 RGBA (the “slaves”) without the need of a

DMX controller. The master unit will be set to operate in either Automatic or Sound-

Active mode, while the slave units will be set to operate in Slave mode. Once set and connected, the slave units will operate in unison with the master unit.

Configure the units as indicated below.

Slave products:

1. Press <MENU> repeatedly until 4-CH or 8-CH shows on the display.

2. Press <ENTER>.

3. Use <UP> or <DOWN> to select starting address d 1.

4. Press <ENTER>.

5. Connect the DMX input of the first slave unit to the DMX output of the master unit.

6. Connect the DMX input of the subsequent slave units to the DMX output of the previous slave unit.

7. Finish setting and connecting all the slave units.

Master products:

1. Set the master unit to operate in either Automatic or Sound-Active mode.

2. Make the master unit the first unit in the DMX daisy chain.

• Configure all the slave units before connecting the master unit to the DMX daisy chain.

• Never connect a DMX controller to a DMX string configured for Master/Slave operation because the controller may interfere with the signals from the master unit.

• Do not connect more than 31 slave units to the master unit.

Page 12 of 15 SlimPAR™ 64 RGBA User Manual (Rev. 1)