- Home
- Domestic appliances
- Climate control
- Split-system air conditioners
- Daikin
- FBQ50BV1A
- Instruction manual
OPTIMUM OPERATION. Daikin FBQ50BV1A
Add to my manuals
13 Pages
Daikin FBQ50BV1A is a split system air conditioner with various operation modes like cooling, heating, automatic, program dry, and fan, suitable for both residential and commercial spaces. It ensures optimum comfort by maintaining the desired temperature efficiently. Its user-friendly remote controller allows for precise temperature adjustment and mode selection. Additionally, the unit's sleek design complements any interior decor.
advertisement
2
PROGRAMMING TIME
Press the PROGRAMMING TIME button and set the time for stopping or starting the system.
When this button is pressed, the time advances by 1 hour.
When this button is pressed, the time goes backward by 1 hour.
3
TIMER ON/OFF
Press the TIMER ON/OFF button.
The timer setting procedure ends.
The display “ or ing light to a constant light.
” changes from flash-
Refer to figure 4 on page [1]
NOTE
• When setting the timer Off and On at the same time, repeat the above procedure from 1 to 3 once again.
When the timer is programmed to stop the system after 3 hours and start the system after 4 hours, the system will stop after 3 hours and then 1 hour later the system will start.
• After the timer is programmed, the display shows the remaining time.
• Press the TIMER ON/OFF button once again to cancel programming. The display vanishes.
7. OPTIMUM OPERATION
Observe the following precautions to ensure the system operates.
• Adjust the room temperature properly for a comfortable environment. Avoid excessive heating or cooling.
• Prevent direct sunlight from entering a room during cooling operation by using curtains or blinds.
• Ventilate the room regularly.
Using the unit for long periods of time requires attentive ventilation of the room.
• Keep doors and windows closed. If the doors and windows remain open, room air will flow out and cause to decrease the effect of cooling and heating.
• Do not place other heaters directly below the indoor unit.
They may deform due to the heat.
• Never place objects near the air inlet and the air outlet of the unit. It may cause deterioration in the effect or stop in the operation.
• Turn off the main power supply switch when it is not used for long periods of time. When the main power switch is turned on, some watts of electricity is being used even if the system is not operating.
Turn off the main power supply switch for saving energy. When reoperating, turn on the main power supply switch 6hours before operation for smooth running (Refer to MAINTENANCE).
• When the display shows “ ” (TIME TO CLEAN
AIR FILTER), ask a qualified service person to clean the filters (Refer to MAINTENANCE).
• It takes time for the room temperature to reach the set temperature.
We recommend starting the operation in advance using timer operation.
8. MAINTENANCE
(FOR SERVICE PERSONNEL)
ONLY A QUALIFIED SERVICE PERSON IS
ALLOWED TO PERFORM MAINTENANCE
IMPORTANT!
• BEFORE OBTAINING ACCESS TO TERMINAL
DEVICES, ALL POWER SUPPLY CIRCUITS
MUST BE INTERRUPTED
• To clean the air conditioner, be sure to stop operation, and turn the power switch off. Otherwise, an electric shock and injury may result.
• Do not wash the air conditioner with water.
Doing so may result in an electric shock.
• Be careful with a scaffold or staging.
Caution must be exercised because of work at a high place.
HOW TO CLEAN THE AIR FILTER <FIELD
SUPPLIED PARTS>
Clean the air filter when the display shows “ ”
(TIME TO CLEAN AIR FILTER).
Increase the frequency of cleaning if the unit is installed in a room where the air is extremely contaminated.
(As a yardstick for regulating yourself, consider cleaning the filter.)
1. Clean the air filter.
Use vacuum cleaner A) or wash the air filter with water B).
A)Using a vacuum cleaner
6
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 1 OPERATION MANUAL
- 2 ILLUSTRATIONS
- 4 WHAT TO DO BEFORE OPERATION
- 4 SAFETY CONSIDERATIONS
- 6 OPERATION RANGE
- 6 INSTALLATION SITE
- 7 NAME AND FUNCTION OF EACH SWITCH AND DISPLAY ON THE REMOTE CONTROLLER
- 7 OPERATION PROCEDURE
- 9 OPTIMUM OPERATION
- 9 MAINTENANCE (FOR SERVICE PERSONNEL)
- 10 NOT MALFUNCTION OF THE AIR CONDITIONER
- 11 TROUBLE SHOOTING