Preparing for Use. Clarke SHHH 2, SHHHAIR 30/9

PREPARING FOR USE

Before connecting your compressor to the mains supply, check the following:-

• Firstly, ensure the compressor is on level ground. Do not allow it to run if it is standing on an incline.

• Check also that the mains voltage corresponds with that shown on the data label on the side of the compressor.

• The ON/OFF switch is in the OFF position.

FITTING THE INLET FILTER

1. Remove the cap from the top of the air inlet tube.

2. Push the air inlet filter supplied securely on to the tube.

5

ADDING OIL

The compressor is supplied without any oil inside.

3. Remove the oil cap from the top of the oil filler tube.

4. Pour the oil into the oil filler tube using the funnel on the bottle, then replace the oil cap.

• Only use Clarke synthetic compressor oil, available from your Clarke dealer (Part No.

3050795).

5. Make sure that the oil level is half way up the oil sight glass

6