Dis-assembling the S45/ME45 . Siemens ME45

Dis-assembling the S45/ME45

A case opener is needed to disengage the latch of the S45/ME45 casing. This case opener is exactly the same as the P35 Series.

PHOTO 2.2 S4/ME45 CASE OPENER



The part number for this mandatory tool is F30032-P46-A1

Refer to ANNEX B of Chapter 3 for Service Equipment List.

STEP 1:

Photo 2.3 Battery cover removing

Remove the battery cover as shown in PHOTO 2.3.

STEP 2:

Photo 2.4. Battery compartment Photo 2.5 Battery Removing

Remove the Battery from the right handside for the compartment as shown in PHOTO 2.5.

Photo 2.6 Backview

The above photo shows the backview of the battery compartment

STEP 3:

Photo 2.7 Opening

Opening the housing with the case opener and carefully pull the lower housing section off as illustrated in PHOTO 2.7

STEP 4:

Photo 2.8 Lower case removng

Remove the lower casing as shown in PHOTO 2.8

STEP 5:

Photo 2.9 RF board removing

Remove the RF board from the upper casing as illustrated in PHOTO 2.9

STEP 6:

Photo 2.10 Keypad PCB and Shield removing

Remove the Keypad PCB from the Upper casing and the shielding from the RF Board as illustrated in PHOTO 2.10

STEP 7

Shield latch

Photo 2.11 Shielding removing

The latch at the side of the shield can be separated from the RF board using a tweezer or finger as illustrated in PHOTO 2.11

STEP 8

Photo 2.12Removing of LCD latches Photo 2..13Disengage the flex cable connector

Using a little force and remove the latch to unlock the LCD from the RF board (PHOTO

2.12) and using your finger or tweezer to disengage the LCD connectors to remove the LCD display as shown in PHOTO 2.13

Internal antenna

Memo button Side button

Infra red window

Vibra motor

Photo 2.14 Lowercase inner view