2.4 Connecting the signals. Barco Coronis 3MP (MFGD-3220-D), MFGD 3220 D, Coronis 3MP MFGD-3220-D

2.4 Connecting the signals

To get access to the connectors, open the cover of the connector compartment by pulling down the

2 clips of the cover.

To connect the video & sync signals:

1 Connect one end of the video cable to the

DVI input (5) of the display.

2

3

Connect the other end of the video cable to the video output of your video source

(Computer graphics board with digital video output).

Route the cable so that it enters the connector compartment at the place where the cover is bulged.

Vid1

Vid2

Example of signal connection in a Coronis dualhead system

To connect the power:

1 Connect the output of the 12V DC power supply to the DC input (6) of the display.

2 Connect one end of the proper power cable to the AC input of the 12V DC power supply.

MFGD 3220D User's Guide 12