Installing Transmitter Battery. Electrix RC ECX3100A, Boost ECX3100, Boost ECX3100AU

EN

INSTALLING TRANSMITTER bATTERIES

1. Slide panel open on bottom of transmitter.

2. Obey battery plus (+) and minus (-) diagram in transmitter to install 8 AA batteries.

3. Slide panel closed on transmitter.

CAUTION: ALWAYS use fully charged batteries in the transmitter. Low battery power can result in loss of control of the RC vehicle.

NEVER install damaged batteries, batteries of mixed types or batteries of different ages in the transmitter.

Remove exhausted batteries.

NEVER store transmitter with batteries installed.

Note: Alkaline AA size batteries are recommended.

INSTALLING TRANSMITTER

ANTENNA

1. Put antenna in hole in top of the transmitter.

2. The collapsed antenna will be 2-1/4 inches long when fully inserted.

3. Turn the antenna clockwise until it is tight.

1

Note: Optional AA NiMH battery charger DYN1970 is available.

Use only batteries approved for use with that charger. DYN1970

2300mAh Tx NiMH Conversion Kit: FUT, ECX.

1

2-1/4 in

(57mm)

2

2 3

3

ChARGING ThE bATTERy

a. Attach battery connector to the charger correctly.

B. 7.2V NiMH battery

c. Compatible Battery Charger

note: Charger power outlet terminals not shown

A b

C

bATTERy WARNINGS ANd GUIdELINES

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

Read all safety precautions and literature prior to use of this product.

Never allow minors to charge battery packs.

Never attempt to charge dead or damaged batteries.

Never charge a battery if the cable has been pinched or shorted.

Never allow batteries or charger to come into contact with moisture at any time. Never charge batteries in extremely hot or cold places (recommended between 50–80 degrees Fahrenheit or 10–27 degrees Celsius) or place in direct sunlight.

Never leave charging batteries unattended.

Never charge batteries outside recommended levels.

Never charge damaged batteries.

Always charge batteries away from flammable materials.

Always use only NiMH rechargeable batteries. This charger cannot charge batteries such as “heavy duty,” “alkaline battery,” or “mercury battery.”

Always connect the positive red lead (+) and negative black lead (-) terminals of the battery to the charger terminals correctly.

Always disconnect the battery and charger after charging, and let them cool between charges.

Always inspect the battery before charging.

Always terminate all processes and contact Horizon Hobby if the product malfunctions.

Always make sure you know the specifications of the battery to be charged or discharged to ensure it meets the requirements of this charger.

Never connect more than one battery pack to this charger at a time.

Always constantly monitor the temperature of the battery pack while charging.

Always end the charging process if the charger or battery becomes hot to the touch or starts to change form during the charge process.

note: The vehicle battery charger produces 500 milliAmps per hour. Divide the mAh capacity on the label of a battery by 500 to know how long battery charging will require. For example, an 1800mAh battery requires 3.5 hours to charge.

4 boost

TM