Operator Safety Instructions. Simpson MINI BRUTE MBII, 60363, MBII, MINI-BRUTE II

DANGER:

DANGER:

DANGER:

DANGER:

WARNING:

WARNING:

WARNING:

WARNING:

WARNING:

WARNING:

WARNING:

CAUTION:

CAUTION:

CAUTION:

CAUTION:

CAUTION:

CAUTION:

CAUTION:

Operating a machine with a ground fault circuit interrupter (GFCI) that has been tampered with, or one that repeatedly trips, could result in an electrocution. Do not remove, disable, or tamper with the GFCI. If the ground fault circuit interrupter repeatedly trips, discontinue use of the machine.

Contact Customer Serive for assistance with the GFCI.

Electrocution could occur if the machine is used on a power circuit that repeatedly trips or is undersized. Have a licensed electrician check the fuse, circuit breaker or power supply, and/or contact

Customer Service for assistance.

Electrocution could occur if maintenance and repairs are performed on a unit that is not properly disconnected from the power source. Disconnect the power supply before attempting any maintenance or service.

Use of this machine with a damaged power cord could result in an electrical shock. Do not use the machine if the power cord is damaged. Do not use the electrical cord to move the machine.

Water under high pressure can cause severe injury. Keep all persons away from the machine and the spray area. Always point the wand toward the object being cleaned.

Injury to the operator or bystanders could occur if the machine is operated without all of the guards being in place on the unit. When operating the machine, all guards must be in place.

Operating a power washer under high pressure without a securely fastened hose, gun, and spray nozzle(s) could result in bodily injury or property damage. Make sure the spray nozzle, gun and hose are securely fastened before operating the machine. Do not remove the nozzle or disconnect the high pressure hose while the system is pressurized and/or running.

Machines have moving parts and hot areas that can cause injury. Keep hands, feet, and loose clothing away from the power washer while it is running. After use, allow an adequate amount of cool-down time before attempting to perform any maintenance or service to this unit.

Failure to wear safety goggles and protective clothing when operating a power washer reduces operator safety. Always wear safety goggles and protective clothing when the machine is running or when operating machine.

Operating this power washer without the appropriate decals could result in operator injury or damage. Make sure all labels and instructional information are fastened to the machine.

Improper discharge of waste water may damage the environment and be illegal. The United States

Environmental Protection Agency has established certain regulations regarding discharge of waste water. Also, city and state regulations regarding this discharge may be in effect in your area.

Understand and follow the regulations in your area. Be aware of the environmental hazards of chemicals that you dispose.

Maintenance and repairs performed by unauthorized personnel could result in damage or injury.

Please contact Customer Sevice.

Electrical damage can occur if the machine is exposed to direct and/or over spray. Always point the wand toward the object being cleaned.

Using an extension cord with your power washer will result in a voltage drop and loss of power. Use of an extension cord is not recommended. If an extension cord must be used, the cord must be

14 gauge and a maximum of 25 ft.

Use of this machine to move other objects or to climb on could result in injury or damage.

Operating a power washer with insufficient water flow can damage the pump. Water should be turned on full-force to avoid insufficient water flow.

Pump damage could occur if the power washer is run for more than five (5) minutes with the trigger released (closed).

Always use Simpson® parts for replacement.

Page 6 Mini-Brute II Owner’s Manual