Now start...

with oven in kitchen.

1 n

Remove shipping materials, tape, and protective film from oven. Do Not remove shipping base at this time.

2 n

Remove the racks and other parts from inside the oven. l l l l

Personal Injury Hazard

Use both hands to remove oven doors

Grasp only the sides of oven doors.

Do Not use handle or any portion of the front frame or trim for lifting.

Because of the weight and size of the ovens, two or more people are needed to move and safely install the ovens.

Failure to properly grasp the oven doors or to lift ovens properly could result in damage to the product or personal injury.

2

d n

Completely open the lower oven door. Remove the two oven door screws,

(Not all models have oven door screws,)

Property Damage

Before moving ovens across floor, check that ovens are on shipping base or slide ovens onto cardboard or hardboard.

Failure to follow these instructions may result in damage to floor covering.

-

6 n

Turn power supply off. Move oven close to final position. Remove and discard shipping base. Feed appliance cable through the opening in cabinet.

Make electrical connection. See

“Electrical requirements” and “Electrical connection” sections, Panel C.

Product Damage

Carefully push against the seal area of the oven front frame when pushing the oven into the cabinet.

Do Not push against outside edges.

Failure to follow these instructions can result in damage to oven finish.

Push against seal area of front frame to push oven into cabinet.

8

H Center oven into cabinet cutout. oven) through the mounting holes in the oven to the cabinet. Do Not overtiahten

4 n

Close lower or single oven door to the broil position. Grasp the sides of the oven door and pull the door up and out of the hinge slots to remove. Set door aside.

I

5

m Repeat Steps 3 and 4 for upper oven.

7 n

Lift oven up into cabinet cutout using the oven opening as an area to grip.

1.

Use one low-profile screw in this position.

9 n

Install the lower vent grille using the three screws provided.

Panel D

Numbers correspond to steps.

13 n

Check the operation of the single or upper oven broil element. Press the “BROIL” button. “500”” will appear in the display. Press the ‘START/ENTER” button to start the broil operation. In l-2 minutes, the upper element should glow red. The single or upper oven indicator light should be on and the oven should be heating.

Press the “OFF/CANCEL” button.

TEMPERATURE

0

SELECTOR

0

Replace the oven racks.

Replace the single oven or upper double oven door by partially fitting the door hinges into the hinge slots. Pull door slightly toward you; then slide door completely in place. Reinstall the two oven-door screws

(if required for your oven door). If door does not close, you have not pushed hinges completely into frame. Repeat for lower oven door.

11 n

Turn on the power supply. ‘PF” should appear in the’temperature display and “88:88” should appear in the clock display. Press the “CLOCK/SET” button. ‘TIME, HR AND MIN” will light in the display. ‘0:OO” will appear and “:” will be flashing. Press the “HOUR” and

“MINUTE” arrows to set the clock to the correct time of day. Press the

“START/ENTER” button to start the clock.

12 n

Check the operation of the single oven or upper oven. Press the

“BAKE” but-ton. ‘350”” will appear in the display. Press the “START/ENTER” button to start the bake operation. In 1-2 minutes, the bottom element should glow red. The upper element should become hot, but not glow red. The single or upper oven indicator light should be on and the oven should be heating.

The oven indicator light goes off when the oven is preheated.

Press the “OFF/CANCEL” button,

TEMPERATURE

0

SELECTOR

Check the operation of the lower oven broil element. Set the oven selector and oven temperature control knobs to

“BROIL.” In l-2 minutes, the upper element should glow red. The lower oven indicator light should be on and the oven should be heating.

Turn the oven selector and temperature control knobs to “OFF.”

You have just finished installing your new Whirlpool oven. To get the most efficient use from your new oven, read f your Whirlpool Use & Care Guide.

I

Congratulations!

I

and Guide close to oven for easy

~~~~~~~

Check the operation of the lower oven.

Set the oven selector control knob to

‘BAKE.” Set the oven temperature control knob to “350°F.” In l-2 minutes, the bottom element should glow red. The upper element should become hot, but not glow red. The lower oven indicator light should be on and the oven should be heating.

The oven indicator light goes off when the oven is preheated.

Turn the oven selector and temperature control knobs to ‘OFF.”

Panel E