Recommended Calibration Conditions. Xerox 490

Prepare for Color Calibration Xerox 490/980 Color Continuous Feed Printing System

Recommended Calibration Conditions

This section describes the recommended conditions for performing the pre-calibration and color calibration procedures in the following chapters.

1.

The printer should be properly maintained in accordance with supplied Xerox documentation.

2.

The paper stock used to perform the pre-calibration and color calibration should be the same paper stock used for jobs that will be submitted after the pre-calibration and color calibration have been successfully performed.

Note

The lamp specification given in the following condition is only a recommendation, not a requirement.

D50 Ra=99, Color rendering AAA, 5000K Extra neutral white fluorescent bulb.

3.

The printer is located in an environment comparable to the B-Zone of the table below:

Environmental Zone

B-Zone

C-Zone

A-Zone

Temp. Range

59

° F to 86° F

15

° C to 30° C

Rel. Humidity Range

30% to 65% RH

50 ° F to 82° F

15 ° C to 27° C

65% - 85% RH

59 ° F to 90° F

15 ° C to 32°

15% to 30%

Comments

The 490/980 CCF

Printing System will deliver optimal performance in this zone.

The 490/980 CCF

Printing System will deliver degraded performance in this zone.

The 490/980 CCF

Printing System will deliver degraded performance in this zone.

3-2 Color Management Guide