Yamaha RX-V395 Receiver

4

CAUTION : READ THIS BEFORE OPERATING YOUR UNIT.

1.

To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference.

IMPORTANT

Please record the serial number of this unit in the space below.

2.

Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming

(transformers, motors). To prevent fire or electrical shock, do not expose the unit to rain or water.

Model:

Serial No.:

3.

Never open the cabinet. If something drops into the set, contact your dealer.

The serial number is located on the rear of the unit.

Retain this Owner’s Manual in a safe place for future reference.

4.

Do not use force on switches, controls or connection wires.

When moving the unit, first disconnect the power plug and the wires connected to other equipment. Never pull the wires themselves.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.

5.

The openings on the unit cover assure proper ventilation of the unit. If these openings are obstructed, the temperature inside the unit will rise rapidly. Therefore, avoid placing objects against these openings, and install the unit in a well-ventilated area to prevent fire and damage.

<China, U.K. and Europe models only>

Be sure to allow a space of at least 20 cm behind, 20 cm on the both sides and 30 cm above the top panel of the unit to prevent fire and damage.

6.

Always set the VOLUME control to “–

∞

” before starting the audio source play. Increase the volume gradually to an appropriate level after playback has been started.

7.

Do not attempt to clean the unit with chemical solvents; this might damage the finish. Use a clean, dry cloth.

8.

Be sure to read the “TROUBLESHOOTING” section regarding common operating errors before concluding that the unit is faulty.

9.

When not planning to use this unit for long periods of time

(i.e., vacation, etc.), disconnect the AC power plug from the wall outlet.

10.

To prevent lightning damage, disconnect the AC power plug and antenna cable when there is an electrical storm.

11.

Grounding or polarization – Precautions should be taken so that the grounding or polarization of an appliance is not defeated.

12.

Do not connect audio equipment to the AC outlet on the rear panel if the equipment requires more power than the outlet is rated to provide.

13.

Voltage Selector <China and General models only>

The voltage selector on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC power supply.

Voltages are 110/120/220/240 V AC, 50/60 Hz.

This unit is not disconnected from the AC power source as long as it is connected to the wall outlet, even if this unit itself is turned off. This state is called the standby mode.

In this state, this unit is designed to consume a very small quantity of power.

FREQUENCY STEP switch <China and General models only>

Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (located on the rear panel) according to the frequency spacing in your area.

Before setting this switch, disconnect the AC power plug of this unit from the AC outlet.

For Canadian Customers

To prevent electric shock, match wide blade of plug to wide slot and fully insert.

This Class B digital apparatus complies with CANADIAN

ICES-003