Switching on. Salora CT1435TDVX

Bediening van teletext (alleen voor de modellen met de teletext)

1. Selecteert u het kanaal met de afstandsbediening dat de teletekstinformatie uitzendt.

2. Roept u de teletekstmodus met de toets TV/TXT uit.

3. Vorm het nummer van de gewenste pagina met de toetsen 0 tot 9 (altijd 3 cijfers). De paginateller van uw toestel begint te zoeken en vervolgens verschijnt uw gekozen pagina met de teletekstrubrieken.

Paginanummer 199

Teletekstinformatie

Rood Groen Geel Blauw

Druk op de gekleurde toets van de afstandsbediening. Pagina’s met de gekleurde rechthoeken van dezelfde kleur verschijnen op het scherm.

4. Om de teletekstmodus te verlaten druk op de toets TV/TXT.

Opmerkingen:

1. Als de televisiezender geen teletekst uitzendt, dan verschijnt op de bovenkant van het scherm de zwarte lijn met het paginanummer.

2. Bediening van teletekst met andere toetsen is op pagina’s 42 en 43 beschreven (“De toetsen van de afstandsbediening”).

44

Switching on

1. Remove the battery cover from the remote control unit and install two AAA type batteries according to the diagram inside the battery compartment. Replace the battery cover.

2. Connect your aerial to the TV set.

3. Connect your TV to a 230 VAC power socket.

4. Switch on your TV with the switch on the front panel. The red light will be illuminated. If the screen does not light up, press a button P- or P+ on the front of the television set or any of the keys P-, P+, 0, 1, ..., 9 and with POWER key on the remote control.

Notes:

1. After switching the television set on by using front panel button, the set switches to the same mode it was before switching of by this button. If TV set was switched off by using the remote control key POWER, it switches to standby and the indicator on the front panel turns red.

2. After switching television set from standby to operating status, the red indicator go down.

Control of TV set by using MENU tables

Note:

Your television set is controlled by using MENU tables Picture,

Install, Setup. These tables appear on the screen after pressing remote control button MENU one or more times. The television set parameters and their values are arranged in these MENU tables.

The line of table with required parameter you can select by using the remote control keys P+ or P-, and to change this parameter by using keys V+ or V-. MENU tables from the TV screen disappears after pressing the remote control key MENU one or several times or about after 5 seconds after the last action in these tables.

The selected line in table is highlighted in red.

Setup

Timer

Organize

Function

Language

English

Franšais

Deutsch

Italiano

Norsk

Svenska

Nederlands

Espa ñ ol

PORTUGU Ê S

Dansk

Suomi

Greek

Selecting the menu language

The selection of language is the following:

1. Press the MENU key on the remote control 3 times. The menu Setup will appear on the screen.

Setup

Timer

Organize

Function

Language

2. Use the P+ or P- to select Language.

3. Press OK. The table with languages will appear on the screen.

4. Use the P+ or P- to select the language you require.

5. Press the MENU key two times to switch off the Setup menu.

English

Franšais

Deutsch

Italiano

Norsk

Svenska

Nederlands

Espa ñ ol

PORTUGU Ê S

Dansk

Suomi

Greek

5