advertisement
Remote control
A 3-volt button cell, type CR2025, is used to power the remote control.
Upon delivery, this button cell is already in the remote control and is secured by a plastic strip. The strip is visible on the back of the remote control. Just carefully pull it out. The remote control is now ready for use.
Changing the batteries
•
•
•
Hold the remote control with the bottom facing up.
Press the bar on the battery compartment to the middle (A) and pull out the compart-
A ment (B).
Take out the empty
B battery (please observe the notes on page 11).
•
•
Insert the new battery in the holder. Thereby the “+” symbol must be visible on the battery and bracket.
Put the holder back into the unit and push the compartment until it locks into place.
Functionality
The remote control transmits the control signals via infrared. For this, it is necessary that you point the remote control towards the ControlStation 2. Make sure no objects are in the way of the infrared signal.
Fluorescent lamps and energy saving lamps installed in the direct vicinity may affect the functions of the remote control or prevent it from working.
Basic functions
Activating and deactivating
After activating, the device is fi rst in standby mode and a blue dot will appear on the display panel 5.
• With the button 1 “Standby” and/or 24 “ ” you can switch the unit between operating and/or standby mode. In the operating state, the active audio source will be shown on the display panel.
Adjusting the volume
• Increasing the volume: Press button 8 “+” and/or 21 “
”.
• Reducing the volume: Press button 9 “–” and/or 22 “
”.
The selected volume will be indicated from 0 to 60 on the display panel 5.
Mute
•
•
With the button 6 “Mute” and/or 18 “ ” you can turn off the sound. The symbol “– –” will appear on the display fi eld 5.
Turning the sound back on: Press button 6 “Mute” and/ or 18 “ ” again or change the volume.
1
Standby Phones
Source Mic
24
22
5
8 • ControlStation 2
6 8 9
Mute
Pure
+
–
18
21
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project