Chapter 1 – Introduction and Safety. Robomow TC300, TC150, RC306, RC304, MC500, MC300, RC302, MC150, TC500

1. Introduction And Safety

EC Declaration of Conformity

Manufacturer: F. Robotics Acquisitions Ltd.

Hatzabar St., Industrial Zone

P.O.Box 1412 Pardesiya,

42815 Israel

The products covered by this Declaration

26 Volt Battery operated Robotic Lawn Mower model:

Robomow RC 302/34/306 MC 150/300/500 and

TC 150/300/500 (with Base Station)

F. Robotics Acquisitions Ltd. declares under sole responsibility that the products identified above conform to the Directives below:

- Machinery Directive 2006/42/EC

Standards referenced: EN ISO 12100:2010.

- EMC Directive 2004/108/EC

Standards referenced: EN 55014-1:2011. EN 55014-2:2008. EN 61000-3-2:2006. EN 61000-3-3:2008.

- Noise Directive 2000/14/EC

Standards referenced: BS EN ISO 3744:2010. ISO 11094:1991.

- RoHS Directive 2011/65/EU.

Technical file representative:

Mr. Gerome De Schutter Friendly Robotics BV.

Address: Expeditieweg 4-6, Andelst 6673, Netherlands.

I hereby declare that the above product conforms to the requirements as specified above

Shai Abramson – Senior VP R&D

F. Robotics Acquisitions Ltd.

Israel

26 November 2013

1.1 Introduction

The products are manufactured by F. Robotics Acquisitions (Friendly Robotics).

© Friendly Robotics, 2014-A. All rights reserved. No part of this document may be photocopied, reproduced, electronically transmitted or translated without the prior written consent of Friendly Robotics.

Product, product specifications and this document are subject to change without notice. All other trademarks are property of their respective owners.

Welcome to the world of home robotics with the Friendly Robotics Robomow!

Thank you for purchasing our product. We know that you will enjoy the extra free time you will have while using Robomow to mow your lawn. When set up and used properly, Robomow will operate safely on your lawn and provide you with a quality of cut matched by a few mowers of any kind. You will be impressed with your lawn’s appearance and best of all,

Robomow did it for you.

IMPORTANT!

The following pages contain important safety and operating instructions. Please read and follow all instructions in this manual. Carefully read and review all safety instructions, warnings and cautions contained in this manual.

Failure to read and follow these instructions, warnings and cautionary statements may result in severe injury or death to persons and pets or damage to personal property.

3

1.2 Warning Decal Definitions

These are the symbols on Robomow  ; Read them carefully before operating Robomow  .

1 2 3 4 5 6 7

1. This is a dangerous power tool. Use care when operating and follow all safety instructions and warnings.

2. Read through the Operating & Safety Manual carefully before operating your Robomow  .

3. Hazard of throwing or flying objects while in operation.

4. Keep a safe distance from Robomow  when operating. Keep people in particular children, pets and bystanders away from the area in which Robomow  is being used.

5. Severing of toes or fingers – Rotary mower blade. Risk of injury from rotating cutting blade. Keep hands and feet away and do not attempt to lift Robomow  from this area.

6. Operate the disabling device before working on or lifting Robomow  .

7. Do not ride on Robomow  .

Do not dispose Robomow  or any other part of it as unsorted municipal waste –

It should be collected separately.

This product conforms to the applicable EU Directives

1.3 Safety Warnings & Precautions

Training -

1. Read this Operating and Safety Manual carefully before operating Robomow  . Be familiar with the controls and the proper use of Robomow  .

2. Never allow people unfamiliar with these instructions or children to use Robomow  .

3. The operator or user is responsible for accidents or hazards occurring to other people or their property.

Preparation -

1. Ensure the correct installation of the Perimeter Wire system as instructed.

2. Periodically inspect the area where Robomow  is to be used and remove all stones, sticks, wires, bones, and other foreign objects.

3. Periodically visually inspect to see that the blade are not worn or damaged. Replace worn or damaged blade in sets to preserve balance.

Operation -

1. Do not operate Robomow  if any safety feature or any part is damaged, worn or inoperable.

2. Keep hands and feet away from the cutting blade and other moving parts.

3. Never pick up or carry Robomow  while the motors are running.

4. Do not leave Robomow  to operate unattended if you know that there are pets, children or people in the vicinity.

5. Never mow while people, especially children, or pets are nearby.

6. Always switch off the Safety Switch before lifting the mower or attempting any adjustments.

7. Do not to touch the blade before the blade have come to a complete stop.

8. Do not use Robomow  for any purpose other than for which it is intended.

9. Keep all guards, shields, safety devices, and sensors in place. Repair or replace damaged parts, including decals.

10. Never pick up or carry Robomow® while the motors are running.

4

Transport –

To safely move from or within the working area:

1. Press the STOP button to stop Robomow  .

2. Use the Remote Control (available as an accessory) to drive it from place to place.

3. In case of different height level, switch off the Safety Switch, and carry the mower by the carrying handle.

4. In case of long transportation, use the original packaging.

5. When transporting Robomow  over long distances switch off the Safety Switch.

IMPORTANT! After turning off the Safety Switch always reset the current day and time. Failure to do so may result in non-intentional operation of the Robomow.

Using Remote Control (Manual Mowing)

1. Mow only in daylight or in a good artificial light and avoid operating in wet grass.

2. Do not operate Robomow  when barefoot or wearing open sandals. Always wear substantial footwear and long trousers; Always be sure of your footing on slopes.

3. Use extreme caution when reversing the mower towards you.

4. Always switch on the motor according to instructions with feet well away from the blade.

5. Do not mow manually in slope greater than 15 degrees or where a firm footing is not possible.

Maintenance and Special Instructions–

1. Always switch off the Safety Switch of Robomow  before clearing blockage/ checking/ cleaning/ working on

Robomow  or replacing the blade. Never attempt to service or adjust the mower while it is in operation.

2. In case of abnormal vibrations, stop the mower, switch off the Safety Switch and check for any damage of the blade. Replace worn or damaged blade to preserve balance. If vibration continues, call for service.

3. Use heavy gloves when inspecting or servicing the blade.

4. Do not perform maintenance when barefoot or wearing open sandals. Always wear suitable work shoes and long trousers;

5. Replace worn or damaged parts for safety.

6. Use only the original equipment and accessories. It is not permitted to modify the original design of Robomow  .

All modifications are made at your own risk.

7. Maintenance/ Servicing / Cleaning of Robomow  should be according to manufacturer’s instructions.

8. Keep all nuts, bolts and screws tight to be sure the machine is in safe working condition.

9. Warning! When there is a risk of a lightning storm, disconnect the Perimeter Wire from the Base Station / Perimeter

Switch and the Power Box 230V/120V plug from the power outlet.

Batteries –

1. Do not open or mutilate the battery pack.

2. The battery pack should be replaced by a service dealer only.

3. The Battery Pack contains electrolytes. In case of an electrolyte leakage from the battery pack, the actions described below are required:

- Skin contact: Wash the contact areas off immediately with plenty of water and soap.

- Eye contact: Flush the eyes with plenty of clean water for at least 15 minutes immediately, without rubbing.

- Get medical treatment.

4. Ensure that the battery pack is charged using the correct charger recommended by the manufacturer. Incorrect use may result in electric shock, overheating or leakage of corrosive liquid from the battery.

Product End of Use -

1. Robomow and its accessories should be collected separately at the end of their life to prevent waste electrical and electronic equipment from ending up in landfill sites, to promote the reuse, treatment and recovery of electrical and electronic equipment with the purpose to preserve, protect and improve the quality of the environment, protect human health and utilize natural resources prudently and rationally.

2. Do not dispose of Robomow or any other part of it (including the Power Box, Base Station and Perimeter Switch) as unsorted municipal waste – it should be collected separately.

3. Ask your local distributor/dealer about return and collection systems available.

4. Do not dispose of the battery pack in a fire and do not place used batteries in your household trash.

5. The battery must be collected, recycled, or disposed of in an environmentally sound manner.

5

1.4 Robomow Safety Features

1. Child Lock

The Child Lock prevents unintended operation of Robomow  by an accidental press of one of the buttons. Only pressing of two buttons in a certain order will initiate the operation.

2. Anti-Theft / Safety Guard

The Anti-Theft system provides the user a disabling function that will prevent anyone from using or driving the Robomow personal security code.

 unless they have the valid code to enter. You will be prompted to enter a four digit code of your choice to use as your

3. Lift Sensor

In the event the mower is raised from the ground during blade operation, the blade will stop rotating immediately.

4. Tilt Sensor

In case the mower is tilted up towards a vertical position, the blade will stop immediately.

5. Obstruction Sensor

Robomow detects when there is an obstacle in its way during operation. When the mower collides with an obstacle, the mower will stop the rotation of the blade immediately, will stop movement in that direction and reverse itself away from the obstacle.

6. Emergency Stop Button

Pressing the STOP button at any time during operation will stop the mower and the blade immediately.

7. Safety Switch

Switching off the Safety Switch will prevent any operation of the Robomow 

Robomow  and before any maintenance is done.

. It is required to switch it off before lifting

8. Sealed Batteries

The batteries that operate the Robomow  position.

are completely sealed and will not leak any type of fluids, regardless of

9. Base Station / Perimeter Switch and Perimeter Wire

Robomow  cannot operate without a Perimeter Wire installed and activated through the Base Station / Perimeter

Switch. In the event the Perimeter Switch is turned off or otherwise fails to function, Robomow  will stop operating.

6