ELECTRONIC VIEWFINDER (EVF). Hitachi VM-6500A, VM-6500A - Camcorder, VTFX6500A, VT-FX6500A

ELECTRONIC VIEWFINDER (EVF) - 8 - cleaning.

"Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to

Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical".

ELECTRONIC VIEWFINDER (EVF)

Set the viewfinder to the position shown in the figure when carrying the camcorder or storing it in the carrying case.

Turn the viewfinder to the position shown below when shooting pictures.

1. Turn the viewfinder.

2. Turn the eyepiece.

You can adjust the position and angle of the viewfinder so you can see through it easily.

CAUTIONS:

• Do not force the viewfinder to rotate completely around. This will damage the viewfinder and/or camcorder.

• When pulling the viewfinder out or returning it to its original position, hold the viewfinder by the swivel section.

Do not hold the diopter control side.

EYEPIECE ADJUSTMENT