Supplied accessories. Philips FW-V355/21M, FW-V355

General Information

IMPORTANT!

PLEASE NOTE THAT THE VOLTAGE

SELECTOR LOCATED AT THE REAR OF

THIS SYSTEM IS PRESET AT 220V FROM

THE FACTORY. FOR COUNTRIES THAT

OPERATE AT 110V-127V, PLEASE ADJUST

TO 110V-127V BEFORE YOU SWITCH ON

THE SYSTEM.

Supplied accessories

– 2 speaker boxes

– remote control

– batteries (two AA size) for remote control

– AM loop antenna

– FM wire antenna

– One Video cinch cable

Environmental information

All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet).

Your system consists of materials which can be recycled and reused if disassembled by a specialised company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.

Safety information

● Before operating the system, check that the operating voltage indicated on the typeplate (or the voltage indication beside the voltage selector) of your system is identical with the voltage of your local power supply. If not, please consult your dealer.

● Place the system on a flat, hard and stable surface.

● Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

● Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

● The lens may cloud over when the system is suddenly moved from cold to warm surroundings, making it impossible to play a disc.

Leave the system in the warm environment until the moisture evaporates.

● The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated.

● When the system is switched to Standby mode, it is still consuming some power.

To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

pg 001-034/V355/21-Eng 7

7

4/17/02, 1:14 PM

3139 115 21372

Preparations

AM loop antenna

FM wire antenna

Television

VIDEO

IN

L

AUDIO

R

OUT

speaker

(right)

AM

ANTENNA

B

FM

ANTENNA

AUX/CDR

R L

SUBWOOFER

OUT

E

—

—

+

R

+

L

SPEAKERS 6 Ω

C

AC power cord

A

VIDEO

OUT

D

VOLTAGE

VOLTAGE

SELECTOR

220V-

240V

110V-

127V

110V-

127V

220V-

240V

speaker

(left)

Rear connections

The type plate is located at the rear of the system.

A Power

Before connecting the AC power cord to the wall outlet, ensure that the following are done;

– If your system is equipped with a

Voltage Selector, set the VOLTAGE

SELECTOR to the local power line voltage.

– All other connections have been made.

VOLTAGE

SELECTOR

110V-

127V

220V-

240V

WARNING!

– For optimal performance, use only the original power cable.

– Never make or change any connections with the power switched on.

B Antennas Connection

Connect the supplied AM loop antenna and FM antenna to the respective terminals. Adjust the position of the antenna for optimal reception.

AM Antenna

● Position the antenna as far as possible from a

TV, VCR or other radiation source.

AM ANTENNA

FM Antenna

● For better FM stereo reception, connect an outdoor FM antenna to the

FM ANTENNA terminal.

8 pg 001-034/V355/21-Eng 8 4/17/02, 1:14 PM

3139 115 21372